Canon 600EX Manual De Usuario

83

a: Fully Automatic Wireless Flash Shooting

When you need more flash output or you 
want to perform lighting more easily, you 
can increase the number of slave units 
and fire them as a single flash.
To add slave units, use the same 
procedure as “Autoflash Shooting Using 
One Slave Unit”. Any firing group (A/B/C) 
can be set.
When the number of slave units is 
increased or master flash firing set to 
ON, automatic control is performed to 
fire all flashes at the same flash output 
and ensure that the total flash output 
results in the standard exposure.

If there is a fluorescent light or PC monitor near a slave unit, the presence of 
the light source may cause the slave unit to malfunction, causing it to fire 
inadvertently.

 

The master/slave flash coverage is set automatically to 24 mm. You can 
also set the flash coverage manually.

 

You can press the depth-of-field preview button on the camera to fire the 
modeling flash (p.38).

 

If the slave unit’s auto power off takes effect, press the master unit’s test 
flash button to turn on the slave unit. Note that the test flash cannot be 
fired while the camera’s metering timer is operating.

 

The autoflash system (E-TTL II/E-TTL) depends on the camera used and 
is set automatically. Note that <a> is displayed on the LCD panel for 
both systems.

 

You can change the time until the slave unit’s auto power off takes effect 
(C.Fn-10/p.98).

 

You can set it up so that the AF-assistant beam emitter will not blink when 

the slave unit recycling is completed (C.Fn-23/p.100).

COP

Y