Honeywell GC-715N24 Manual De Usuario

Installation

Mounting a Lens

1. Remove the protective cap in front of the camera.
2. Confirm the mount ring whether it is for C or CS. * Caution1
3. Attach the lens to the lens mount ring.
4. If the lens has an Auto Iris mechanism, connect the iris cable to the Lens connector

(EE/VSD S/W must be set to VSD on the side of the camera)
A. In the case of having no iris amplifier : Set the slide switch to DC (Down side)
B. In the case of having iris amplifier : Set the slide switch VSD (Upper side)
C. Set the S/W on the side of the camera to DC or VSD, too.

☞

If using lens that has iris amplifier, “LEVEL” and “ALC” volume of lens must be

adjust carefully. It may cause any hunting.

☞

When connecting Auto iris lens, be sure to use the connector to be recommended

by manufacturer. (E4-191, Chuo Musen, Japan)

* Caution 1 : This appliance is set to CS mount default.

If you want to use C mount lens, fix a C adapter ring additionally packed
in the box.

When Auto-Iris Lens is used...

VSD LENS PIN CONFIGURATION

①③

④

②

1. POWER(12V) 2. NO CONNECTION

3. VIDEO SIGNAL 4. GND

Set the select switch to VSD

DC IRIS LENS PIN CONFIGURATION

①③

④

②

1. CONTROL-

2. CONTROL+

3. DRIVE+ 4. DRIVE-

Set the select switch to DC

* For the best condition, read lens manual carefully .
* After connecting Auto iris-lens you may need to set flange back focus.

Connection of AC power supply

☞

Must be checked the power source from the external power supply before power on.

☞

Recommended power source capacity :

AC 24V, more than 500mA