Nikon L14 Manual De Usuario
27
Using the Flash
Basic Photogra
phy and
Playback: Easy Auto Mode
B
The W (Off) Indicator
Note the following when lighting is poor and the flash is off (W):
• Place the camera on a flat, level surface or use a tripod (recommended).
• The E symbol is displayed when the camera automatically increases sensitivity. Pictures taken
• Place the camera on a flat, level surface or use a tripod (recommended).
• The E symbol is displayed when the camera automatically increases sensitivity. Pictures taken
when E is displayed may be slightly mottled.
B
Note on Using the Flash
When using the flash at a wide-angle zoom position, reflections from dust particles in the air may
appear as bright spots in pictures. To reduce these reflections, set the flash to W (Off) or zoom in on
the subject.
appear as bright spots in pictures. To reduce these reflections, set the flash to W (Off) or zoom in on
the subject.
C
The Flash Lamp
The flash lamp indicates flash status when the shutter-
release button is pressed halfway.
• On: Flash will fire when picture is taken.
• Blinks: Flash charging. Wait a few seconds and try
release button is pressed halfway.
• On: Flash will fire when picture is taken.
• Blinks: Flash charging. Wait a few seconds and try
again.
• Off: Flash will not fire when picture is taken.
After the picture is taken with flash, the monitor turns
off and the flash lamp blinks until the flash is
completely charged. You can set the monitor not to turn off automatically while the flash is charged
(
After the picture is taken with flash, the monitor turns
off and the flash lamp blinks until the flash is
completely charged. You can set the monitor not to turn off automatically while the flash is charged
(
A 91).
C
The Flash Mode Setting
The default setting is U (auto). (except for the one-touch portrait mode and a part of Scene
mode)
mode)
In any flash mode other than A (auto) mode, switching to another shooting mode or turning the
camera off restores the default flash setting for all modes.
camera off restores the default flash setting for all modes.
C
Red-eye Reduction
The COOLPIX L14 is equipped with an advanced red-eye reduction system. Pre-flashes are fired
several times at low intensity before the main flash, to reduce “red-eye.” If the camera detects “red-
eye” after a picture is taken, Nikon’s own In-Camera Red Eye Fix processes the image as it is recorded.
Therefore, there is a slight delay before the shutter-release button operates normally to take another
picture. Note the following when using red-eye reduction:
• Not recommended for when shutter-release timing is essential.
• It takes a longer time than usual to start the next shooting.
• Red-eye reduction may not always produce the desired results.
• In some rare cases, other portions of pictures may be affected.
Use flash modes other than auto with red-eye reduction in above cases.
several times at low intensity before the main flash, to reduce “red-eye.” If the camera detects “red-
eye” after a picture is taken, Nikon’s own In-Camera Red Eye Fix processes the image as it is recorded.
Therefore, there is a slight delay before the shutter-release button operates normally to take another
picture. Note the following when using red-eye reduction:
• Not recommended for when shutter-release timing is essential.
• It takes a longer time than usual to start the next shooting.
• Red-eye reduction may not always produce the desired results.
• In some rare cases, other portions of pictures may be affected.
Use flash modes other than auto with red-eye reduction in above cases.
Flash lamp