Nikon COOLPIXS70BK Manual De Usuario

Adjusting the Camera Settings in Shooting Mode

More on 

Sh
ooting

B

Shooting When the Flash is Disabled (W) or Lighting is Poor

• Use of a tripod is recommended to stabilize the camera during shooting. Set Vibration 

reduction (

A 147) to Off from the setup menu (A 139) when using a tripod to stabilize the 

camera.

• Pictures taken when the ISO sensitivity is increased may be slightly mottled.
• Noise reduction may be performed for pictures taken at slow shutter speeds. More time than usual 

is required to record pictures to which noise reduction is applied.

C

The flash indicator shows flash status when the shutter-
release button is pressed halfway.

• On: Flash will fire when picture is taken.
• Blinks: Flash charging. Wait a few seconds and try 

again.

• Off: Flash will not fire when picture is taken.
If the battery is low, the monitor will turn off, and remain 
off, while the flash charges.

C

The flash mode setting applied in A (auto) mode is stored in the camera’s memory even after the 
camera is turned off, and reapplied the next time A (auto) mode is selected.

C

This camera uses advanced red-eye reduction (“In-Camera Red-Eye Fix”). The flash fires repeatedly at 
low intensity before the main flash, reducing red-eye. The camera then analyzes the picture; if red-
eye is detected, the affected area will be processed to further reduce red-eye before the picture is 
saved. Note that because there is a slight lag between the shutter-release button being pressed and 
the picture being taken, this mode is not recommended when a quick shutter response is required. 
The time until the picture is stored also increases slightly. Advanced red-eye reduction may not 
produce the desired results in all situations. In extremely rare instances, areas not subject to red-eye 
may be affected by advanced red-eye reduction processing; in these cases, choose another flash 
mode setting and try again.

1/125  F3.9

1/125  F3.9