Nikon 25478 Manual De Usuario

Descargar
Página de 92
12
X
First Steps
Always turn the camera off before inserting or removing batteries or memory cards.
1
Charge the battery.
If a plug adapter is supplied, raise the wall plug and connect the plug adapter 
as shown below at left, making sure the plug is fully inserted. Insert the battery 
and plug the charger in. An exhausted battery will fully charge in about an hour 
and thirty minutes.
2
Insert the battery.
Check to be sure the battery is in the correct orientation.
Battery
charging
Charging 
complete
D
Charging the Battery
Read and follow the warnings and cautions on pages ii–iii and 69–71 of this manual
Charge the battery indoors at ambient temperatures of 5–35 °C (41–95 °F). Do not use 
the battery at ambient temperatures below 0 °C/32 °F or above 40 °C/104 °F; failure to 
observe this precaution could damage the battery or impair its performance. Capacity 
may be reduced and charging times may increase at battery temperatures from 0 °C/
32 °F to 15 °C/59 °F and from 45 °C/113 °F to 60 °C/140 °F. The battery will not charge 
if its temperature is below 0 °C (32 °F) or above 60 °C (140 °F). If the CHARGE lamp flickers 
during charging, confirm that the temperature is in the correct range and then unplug 
the charger and remove and reinsert the battery. If the problem persists, cease use 
immediately and take battery and charger to your retailer or a Nikon-authorized 
service representative.
Use battery to press
orange battery
latch to one side.
Latch clicks into
place when battery
is fully inserted.