Casio EX-ZS5PK Manual De Usuario

49

Recording Movie Images and Audio

• Spending a long time using movie recording will cause the camera to become 

slightly warm to the touch. This is normal and does not indicate malfunction.

• The camera also records audio. Note the following points when 

shooting a movie.
– Take care that the microphone is not blocked by your fingers, 

etc.

– Good recording results are not possible when the camera is 

too far away from what you are trying to record.

– Operating camera buttons while shooting can cause button 

noise to be picked up in the audio.

• Shooting a very bright subject can cause a vertical band or a pink cast on the 

monitor screen image. This does not indicate malfunction.

• When using the camera’s built-in memory or certain types of memory cards, it can 

take too much time to record data, which can result in breaks in the image and/or 
audio. This condition is indicated by » and Y flashing on the monitor screen. To 
avoid loss of movie frames, use of a memory card with a maximum transfer speed 
of at least 10MB per second is recommended (page 125).

• Only digital zoom can be used for zooming during movie recording. Since optical 

zoom is not possible while recording a movie, zoom as required before pressing 
[0] (Movie) to start recording.

• The effects of camera movement in an image become more pronounced when you 

shoot close up or with a large zoom factor. Because of this, use of a tripod is 
recommended under these conditions.

• Focus is fixed while movie recording is in progress.

Movie recording continues after the snapshot is recorded.

• You can use [2] ( ) while shooting a movie to change the flash mode setting.
• Movie recording is interrupted for a few seconds at the point where a snapshot is 

recorded.

• Shooting a snapshot during movie recording is not possible when shooting with 

any of the following.
– Some BEST SHOT scenes
– easy Mode

Microphone