Casio EX-FH100 Manual De Usuario

191

Appendix

Language selection 
screen appears 
when the camera is 
turned on.

1)You did not configure initial settings after purchasing the 

camera or the camera may have been left with a dead 
battery. Configure the correct settings (pages 19, 166).

2)There may be a problem with the camera’s memory data. If 

this is the case, perform the reset operation to initialize the 
camera’s setup (page 170). After that, configure each setting. 
If the language selection screen does not re-appear when you 
turn the camera on, it means that the camera’s memory 
management data has been restored.
If the same message appears after you turn power back on, 
contact your retailer or a CASIO authorized service center.

The time and date 
settings configured 
the first time after 
purchasing the 
camera are reset to 
their factory 
defaults when I 
remove the 
camera’s battery.

Load the camera’s battery and reconfigure the time and date 
settings (page 19). Do not remove the battery from the camera 
for at least 24 hours after configuring time and date settings. 
After that, the settings will not be reset if you remove the 
battery.

• If the time and date are reset to their factory default settings 

when you remove the battery after it has been loaded for 
more than 24 hours, it could mean that the camera’s setting 
memory is defective. Contact your retailer or a CASIO 
authorized service center.

Buttons are not 
responsive right 
after the power has 
been turned on.

With large capacity memory cards there is a delay after the 
power has been turned on before the buttons become 
responsive.

The camera’s protection function may have activated 
because camera temperature is too high. Turn off the 
camera and wait until it cools down before trying to use it 
again.

Battery power is low.

The camera could not go into auto record standby for some 
reason during a Move Out CS or Move In CS operation. 
Compose the image again with the boundary aligned 
correctly (page 81).

The image you specified with the slideshow “Images” 
setting cannot be found. Change the “Images” setting (page 
120) and try again.

You are attempting to save a user BEST SHOT scene in 
the “SCENE” folder when the folder already contains 999 
user scenes.

B