Viewsonic VT3245-NT Manual De Usuario

Descargar
Página de 34
VT3245-NT/VT3745-NT/VT4245-NT
Antenna Installation Instructions
Outdoor Antenna Grounding
 
If an outside antenna or cable system is connected to the product be sure the antenna or cable 
system is grounded so as to provide some protection against voltage surges and built-up static 
charges, Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with 
regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to 
an antenna discharge unit, connection to grounding electrodes, and requirements for the grounding 
electrode.
Lightning
 
For added protection for this product during a lightning storm, or when it is left unattended and 
unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable 
system. This will prevent damage to the product due to lightning and power-line surges. Do not 
disconnect the antenna or the power cord during a heavy storm lighting may strike while you are 
holding the cable cord, causing serious injury; turn off your LCD Display and wait for the weather 
to improve.
Power Lines
 
An outside antenna system should not be located in the vicinity of overhead power lines or 
other electric light or power circuits, or where it can fall into such power lines or circuits, When 
installing an outside antenna system, extreme care should be taken to keep from touching such 
power lines or circuits as contact with them might be fatal.
Antenna
Antenna discharge unit
Power service grounding electrode system 
Ground clamps
Electric service equipment
Ground clamp
Grounding conductors
Cleaning the LCD Display
Make sure the LCD Display is turned off.
Never spray or pour any liquid directly onto the screen or case.
To clean the screen:
Wipe the screen with a clean, soft, lint-free cloth. This removes dust and other particles.
If still not clean, apply a small amount of non-ammonia, non-alcohol based glass cleaner onto a 
clean, soft, lint-free cloth, and wipe the screen.
To clean the case:
Use a soft, dry cloth.
If still not clean, apply a small amount of a non-ammonia, non-alcohol based, mild non-abrasive 
detergent onto a clean, soft, lint-free cloth, then wipe the surface.
Disclaimer
ViewSonic® does not recommend the use of any ammonia or alcohol-based cleaners on the LCD Display 
screen or case. Some chemical cleaners have been reported to damage the screen and/or case of the LCD 
Display. ViewSonic will not be liable for damage resulting from use of any ammonia or alcohol-based 
cleaners.
1.
2.
3.

1.
2.
1.
2.
4
ViewSonic
ENGLISH