Panasonic DMC-LX100 Manual De Usuario

Descargar
Página de 332
314
SQW0021
Others
Q&A  Troubleshooting
 
Monitor/viewfinder
The monitor/viewfinder is turned off although the camera is turned on.
 •When a hand or object is close to the eye sensor, the monitor display mode could be switched to 
viewfinder display mode without your knowledge. 
Pictures do not show on the monitor.
 •Viewfinder display mode is activated.
→  Press the [LVF] button to switch to the monitor display mode. 
 •Monitor is turned off.
→  Press the [DISP.] button to switch the display information. 
 •When you connect the camera to a TV using an HDMI micro cable, the picture is not displayed on 
a monitor/viewfinder in the following cases.
 
– During playback
Brightness is unstable.
 •Aperture value is set while shutter button is pressed halfway. (Does not affect recorded picture.) 
This symptom may also occur when the brightness changes because the zoom is operated or the 
camera is moved. This is the automatic aperture operation of the camera and is not a malfunction.
The screen flickers indoors.
 •The screen may flicker for a few seconds after turning on. This is an operation to correct flicker 
caused by lighting such as fluorescent lights, LED lights, etc. and is not a malfunction.
The screen is too bright/too dark.
 •Check [Monitor Luminance] setting. 
 •Use [Monitor Display]/[Viewfinder] to adjust the brightness of the screen. 
Black/blue/red/green dots or interference appears. Monitor looks distorted when touched.
 •This is not a fault, and will not be recorded on the actual pictures.
Noise appears on the monitor/viewfinder.
 •In dark places, noise may appear to maintain the brightness of the monitor/viewfinder.
Cannot switch between the monitor and viewfinder when pressing [LVF] button.
 •When it is connected to a computer or printer, the camera can display pictures on the monitor only.