Sony HDR-HC5 Manual
14
Step 2: Charging the battery pack
You can charge the “InfoLITHIUM”
battery pack (H series) (p. 95) after
attaching it to your camcorder.
battery pack (H series) (p. 95) after
attaching it to your camcorder.
b
Notes
• You cannot attach any “InfoLITHIUM” battery
pack other than the H series to your camcorder.
1
Attach the battery pack to your
camcorder.
camcorder.
Attach the battery pack by sliding it in
the direction of the arrow until it clicks.
the direction of the arrow until it clicks.
2
Slide the POWER switch to OFF
(CHG) (the default setting).
(CHG) (the default setting).
3
Connect the AC Adaptor to the
DC IN jack of your camcorder. Be
sure that the v mark on the DC
plug is facing to the v mark on
your camcorder.
DC IN jack of your camcorder. Be
sure that the v mark on the DC
plug is facing to the v mark on
your camcorder.
4
Connect the power cord to the AC
Adaptor and the wall outlet.
Adaptor and the wall outlet.
The /CHG (charge) lamp lights up and
charging starts. The /CHG (charge)
lamp turns off when the battery is fully
charged.
charging starts. The /CHG (charge)
lamp turns off when the battery is fully
charged.
b
Notes
• Disconnect the AC Adaptor from the DC IN
jack holding both the camcorder and the DC
plug.
plug.
z
Tips
• You can operate your camcorder connected to a
power source such as a wall outlet as shown in
the illustration. The battery pack will not lose its
charge in this case.
the illustration. The battery pack will not lose its
charge in this case.
1
2
4
3
4
Battery pack
To the wall outlet
Power cord
AC Adaptor
/CHG
(charge)
lamp
lamp
DC IN jack
POWER
switch
switch
DC plug