Geneva Lab 3206 Manual De Usuario
6
G E N E V A
-
H O T B E V E R A G E M E R C H A N D I S E R • 3 2 0 5 • 3 2 0 6 • 4 2 1 4 8 0 3
FILL PRODUCT CANISTERS
WARNING: FILL PRODUCT CANISTERS WITH POWDERED INGREDIENTS ONLY.
DO NOT USE LIQUID INGREDIENTS.
Figure 5b. Product Chute
Figure 5a. Canister Lineup
Figure 5c. Locator Peg
Figure 5d. Motor Shaft
Figure 5e. Canister Lid
1.
Always remove the ingredient canisters in order to fill them. This
prevents spillage of foodstuffs which will encourage the ingress of
insects etc.
prevents spillage of foodstuffs which will encourage the ingress of
insects etc.
2.
Prior to removing an ingredient canister, rotate the delivery chute in
an upward direction to prevent spillage of product onto internal
surfaces. See Figure 5b.
surfaces. See Figure 5b.
3.
When removing each ingredient canisters, always give it a shake to
loosen-up any compacted product to keep it free-flowing.
loosen-up any compacted product to keep it free-flowing.
4.
When filling the canisters, hold the top and bottom of the canister
and slowly lift it up so that the locator peg clears the peg hole.
Figure 5c. Slide the canister forward until it is out of the ingredient
motor shaft. Figure 5d.
and slowly lift it up so that the locator peg clears the peg hole.
Figure 5c. Slide the canister forward until it is out of the ingredient
motor shaft. Figure 5d.
5.
Place canister on a sheet of paper or on an easily cleaned surface.
6.
Remove lid from the canister. Figure 5e.
7.
Open product bag that matches the name on the Canister Label
(where applicable) according to the instructions on the bag.
8.
Slowly pour the product into the canister. Figure 5f.
•
•
Product must be loose for proper dispensing.
•
DO NOT tap the sides of the canister.
•
DO NOT compress or compact product into the canister.
•
Leave a gap from the top of the product to the lip of the
canister. Figure 5g.
canister. Figure 5g.
9.
Replace canister lid. Figure 5e.
10. Review the canister arrangement as shown in Figure 5a. Hold the
canister carefully at the bottom and top to prevent spilling. Gently
place the filled canister back on the product shelf. Figure 5d.
place the filled canister back on the product shelf. Figure 5d.
11. Line up the hollow shaft in the back of the canister with the
ingredient motor shaft. See Figure 5d.
12. Slowly slide the canister toward and over motor shaft until locator
peg falls inside the hole on the product shelf. See Figure 5c.
Figure 5f. Fill Canister