Sharp BD-HP20H Manual De Usuario

SETTINGS

Speakers

Selectable size

L/R

LARGE*, SMALL

C/RS/LS

LARGE*, SMALL, NONE

YES*, NO

* Factory preset

LARGE: The cone diameter is 16 cm or larger.
SMALL: The cone diameter is smaller than 16 cm.

Selectable Distance
range

0.1m through 9.0m
(Settings available in 0.1m increments)

The factory preset value: 3.8m(L/R/C)
2.0m(RS/LS)

Selectable Output
Level range

-6dB through +6dB
(Settings available in 1dB increments)

The factory preset value is 0dB.

0dB
SW

3.8m/0dB
L

2.0m/0dB

3.8m/0dB

MENU [SPEAKER SETTINGS]

TEST START

FINISH

Press

c/d to select the preferred item, then

press

a/b to select the preferred setting, then

press ENTER.

0dB
SW

3.8m/0dB
L

2.0m/0dB

3.8m/0dB

MENU [SPEAKER SETTINGS]

LARGE

3.8 m

0dB

SIZE DISTANCE LEVEL

Repeat steps 5 and 6 until each speaker's size,
distance, and level are set.

NOTE

• The speakers L and R, LS and RS move relative to one another.
• The speakers L and R are automatically set to “LARGE” when the

subwoofer SW is set to “NO”, even after speakers L and/or R are
set to “SMALL”.

• The images of speakers set to “NONE” disappear or are greyed

out on the screen.

• As for a subwoofer, there are no settings for distance.

Press

a/b/c/d to select the speaker, then

press ENTER.

0dB
SW

3.8m/0dB
L

2.0m/0dB

3.8m/0dB

MENU [SPEAKER SETTINGS]

TEST START

FINISH

Checking the setup sound

Press

a/b/c/d to select “TEST START”, then

press ENTER.

0dB
SW

3.8m/0dB
L

2.0m/0dB

3.8m/0dB

MENU [SPEAKER SETTINGS]

TEST START

FINISH

• After switching to TEST mode, you can hear the Test

sound from each speaker in turn.

• If you press

a/b/c/d to select the preferred

speaker while the TEST sound is present, you
can hear the TEST sound of the speaker that you
selected.

• If you press

a/b/c/d to select “TEST TONE

STOP” and press ENTER, you can stop the Test
sound