Guardian Technologies DFT 150/175 Manual De Usuario
AT&W<RET>
<ESC>
QUIT <RET>
<ESC>
QUIT <RET>
These commands are entered using
Setup Mode on the DVST0200 unit via
a PC. Refer to Chapter para
Setup Mode on the DVST0200 unit via
a PC. Refer to Chapter para
The Citam is configured to operate on DVST.
X21
Cables required - 2x15 to 15 (Part No. AS-DVST-X21)
Dip switch settings can be used and should be set as follows:
Note:
Switch 3 selects the sub address, if used
Step
Instruction
Remarks
1
Using the pull handle, remove the
circuit board module from the Citam
500
circuit board module from the Citam
500
2
Adjust the dip switches as shown in
Figure 10
Figure 10
The Citam will nowperform a self test
On completion the dispaly will read
ISDN
ISDN
3
Press the select key four times so
that the legend ‘CONF’ appears on
the display
that the legend ‘CONF’ appears on
the display
4
Press the enter key once and it will
say ‘PRT1’, press the select key
twice it will say ‘TA’ , press the enter
key it will say ‘SHOW’
say ‘PRT1’, press the select key
twice it will say ‘TA’ , press the enter
key it will say ‘SHOW’
5
Press the hold select until the display
reads ‘CHNG’ remove your finger
from the select key and press the
enter key, ‘INDB’ will be displayed
reads ‘CHNG’ remove your finger
from the select key and press the
enter key, ‘INDB’ will be displayed
6
Press theenter key, themessage will
be ‘ON’,use the select key to turn this
to ‘OFF’, then press the enter key
be ‘ON’,use the select key to turn this
to ‘OFF’, then press the enter key
7
Hold the select key and press the
enter key, the display will return to
‘CONF’
enter key, the display will return to
‘CONF’
This has turned off the in-band test
feature of the unit
feature of the unit
8
At ‘CONF’ press the enter key, the
display will read ‘PRT1’ for port 1
display will read ‘PRT1’ for port 1
Page 36
Dedicated Micros Ltd
Terminal Adapters
DVST Installation Guide
Fig 6: ASCOM internal dip switch settings (X21)