Avaya 03-300430 Manual De Usuario

The Blue Alarm is a signal sent by the remote DS1 endpoint when it is out-of-service. The Blue 
Alarm Inquiry Test checks the blue alarm status of the remote DS1 endpoint.
When the MM710 Interface Media Module detects a Blue Alarm signal from the remote DS1 
endpoint, the Media Module transmits a Yellow alarm to the remote DS1 endpoint and sends a 
BLUE ALARM message to the maintenance software. When the Blue alarm is confirmed, the 
maintenance software places all trunks or ports of the MM710 Interface Media Module into the 
out-of-service state. The inquiry test runs every 10 minutes until the Blue alarm is cleared.
The MM710 Interface Media Module takes one second to recognize and report a Blue alarm 
and 16 seconds to recognize and report the resolution of a Blue alarm. When the Blue alarm is 
cleared, the MM710 Interface Media Module stops transmitting the Yellow alarm and places the 
trunks or ports back into the service state they were in before the Blue alarm occurred.

Any

NO

BOARD

The test could not relate the internal ID to the port (no board). This could 
be due to incorrect translations, no board is inserted, an incorrect board 
is inserted, or an insane board is inserted.

1. Ensure that the board translations are correct. Execute the add 

ds1 location command to administer the MM710 interface if it is 

not already administered.

2. If the board was already administered correctly, check the error log 

to determine whether the board is hyperactive. If this is the case, the 
board is shut down. Reseating the board will re-initialize the board.

3. If the board was found to be correctly inserted in step 1, then enter 

the busyout board location command.

4. Enter the reset board location command.
5. Enter the release board location command.
6. Enter the test board location long command. 

This should re-establish the linkage between the internal ID and the port.

 4 of 4