Avaya 03-300430 Manual De Usuario

The Conference Circuit test verifies that the NPE channel for the port being tested can correctly 
perform the conferencing function. The NPE is instructed to listen to several different tones and 
conference the tones together. The resulting signal is measured by a tone detector port. If the 
level of the tone is within a certain range, the test passes.

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

System resources required to run this test are not available. The port may 

be in use on a valid call. Use status pri-endpoint extension 

commands to determine when the port is available for testing.

1004

ABRT

The port has been seized by a user for a valid call. Use status 
pri-endpoint extension to determine when the port is available for 

testing.

1. Retry the command at 1-minute intervals up to 5 times.

1020

ABRT

The test did not run due to an already existing error on the specific port or a 
more general circuit pack error.

1. Examine Error Log for existing errors against this port or the circuit 

pack and attempt to diagnose the already existing error.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

Any

FAIL

The NPE of the tested port did not conference the tones correctly. This will 
cause noisy and unreliable connections.

1. Replace the circuit pack. Even though wideband calls do not use the 

conferencing feature on the NPE, this failure indicates problems with 
the circuit pack hardware.

PASS

The port can correctly conference multiple connections. User-reported 

troubles on this port should be investigated using other port tests and 

examining terminal adapter or external wiring.