Avaya 03-300430 Manual De Usuario

1301

FAIL

The 120A1 CSU module or the 401A T1 sync splitter, or the 402A or 403A 

E1 synchronization splitter is not expected.
The 120A1 CSU module or the 401A T1 sync splitter is not expected: The 
120A1 CSU module/T1 sync splitter is physically connected to the UDS1 
board on the back of the port carrier, but the Near-End CSU Type field on 
the add ds1 screen has not been administered as integrated.

1. If the 120A1 CSU module/T1 sync splitter is to be used, use change 

ds1 to set the Near-End CSU Type field to integrated. Otherwise, 

physically remove the 120A1 CSU module/T1 sync splitter from the 
back of the port carrier.

2. Run the test again.

The 402A or 403A E1 synchronization splitter is not expected: The 402A 
or 403A E1 synchronization splitter is physically connected to the UDS1 
board on the back of the port carrier, but the E1 Sync-Splitter? field on 
the add ds1 screen has not been administered as y.

1. If the 402A or 403A E1 synchronization splitter is to be used, use 

change ds1 to change the E1 Sync-Splitter field to y. Otherwise, 

physically remove the 402A or 403A E1 synchronization splitter from 
the back of the port carrier.

2. Run the test again.

1302

FAIL

Attempting to use the 120A1 CSU module with a UDS1 circuit pack that is 
configured for 32-channel (2.048-Mbps) operation. The CSU module only 
works with a DS1 board configured for 24-channel (1.544-Mbps) 
operation in the United States of America.

1. If the 120A1 CSU module is to be used, physically remove the UDS1 

circuit pack and reconfigure it for 24-channel (1.544-Mbps) operation.

2. Reinsert the circuit pack and run the test again.

 4 of 9