Avaya 03-300430 Manual De Usuario

Notes:

a. Error Type 0: Run the short test sequence first.  If every test passes, run the long test 

sequence.  Refer to each appropriate test’s description, and follow its recommended 
procedures.

b. Error Type 1: the circuit pack totally stopped functioning or it was physically removed from 

the system. The alarm is logged approximately 11 minutes after the circuit pack has been 
removed and/or SAKI Sanity test (#53) fails.

If the circuit pack is not in the system, insert a circuit pack (in the same slot as the error 
indicates) to resolve this error.  Or, if the circuit pack is in the system and the red LED is on, 
follow the instructions for “Red (alarm)” in 

c. Error Type 18: This circuit pack has been busied out via busyout board location.

d. Error Type 23: Port(s) has (have) been administered on this circuit pack but the circuit pack 

is not physically present.

e. Error Type 257: transient communication problems between the switch and this circuit 

pack.  Execute  test board location and see 

on page 2400 for the repair procedures.

f. Error Type 513: An on-board hardware failure has been detected by the circuit pack.

Aux Data 4352: External RAM error
Aux Data 4353: Internal RAM error
Aux Data 4355: ROM Checksum error
Aux Data 4357: Instruction set error

Reset the circuit pack by executing busyout board location and reset board 
location.  When it is reset, the circuit pack executes a set of tests to detect the presence 

of any of the above faults.  The detection of one of these errors during initialization causes 
the circuit pack to lock-up and appear insane to the system.  See the repair procedure in 
footnote (a) for error type 1.

2306 (

)

LANBIC Receive 

Parity Error 

Counter test 

(#595)

3330 (

46083

MIN

OFF

3840 

)

4096 to 

4101

3843 (

) 46097

3999 (

) Any

None

 2 of 2