Bionaire BCM4510 Manual De Usuario

• Power light not illuminated.

• “Empty/Refill” light 

illuminated. 

• Mist output minimal to

none.

• Water leaks from water 

reservoir.

• Water Filter turns brown.

• Film on water reservoir.

• Water cloudy.

• Humidistat cycles on/off.

• Very tight reservoir cap.

☛ Unit not plugged in. 
☛ Power failure.

☛ Water reservoir empty.
☛ Scale build-up in 

base.

☛ Scale build up on float

☛ Filter has not 

absorbed water.

☛ Mineral buildup in base.

☛ Humidistat is set too low.

☛ Wick Filter needs 

to be replaced.

☛ Normal operation.

☛ Rubber O-ring is missing

or improperly placed.

☛ Reservoir Cap not 

tight enough.

☛ Your filter needs  

to be changed.

☛ In areas with particular 

hard water your wick 
filter will need to be 
changed frequently.

☛ Mineral deposits cause 

film on tank to build up.

☛ Filter needs  

to be replaced.

☛ Using warm water

to refill reservoir.

☛ Humidifier is reacting 

to room humidity level.

☛ Over tightened.

✔ Plug in unit.
✔ Check circuit breaker or 

outlet.

✔ Refill Water reservoir.
✔  Remove base and flush 

out residue.

✔ Clean float tubes and 

float.

✔  Wait 15 minutes before 

starting humidifier.

✔ Regular cleaning of tray

after each use will help
keep the unit functioning
properly.

✔ Set the humidistat to 

high.

✔  Replace your wick filter 

(WF2630) by calling 
1-800-253-2764, or visit 
www.bionaire.com.

✔ Mist is invisible.
✔ Check to see if inlet or 

outlet grills are blocked

✔  Remove reservoir 

cap then replace 
or reposition ring.

✔ Tighten the 

reservoir cap.

✔  Replace your wick filter 

(WF2630) by calling 
1-800-253-2764, or visit 
www.bionaire.com.

✔ Use Clean Away Solution

(DMS216), to order call 
1-800-253-2764, or visit
www.bionaire.com.

✔ Replace your wick filter

(WF2630) by calling 
1-800-253-2764, or visit
www.bionaire.com.

✔ Refill using cool water.

✔ Set the humidistat to a

higher or lower setting.

✔ Add liquid soap or 

pertroeum jelly to cap 
gasket to ease opening.