Hampton Bay 165 474 Manual De Usuario

Figure 10

Motor 
Collar

Screw and Lock Washer
(3 of 6 Places)

Remove the canopy ring from the canopy. 
(Figure 5)

Remove the mounting bracket from the canopy 
by loosening the four screws on the top of the 
canopy. Remove the two non-slotted screws 
and loosen the slotted screws (Figure 6).

1.

2.

Remove the decorative canopy bottom cover 
from the canopy by turning the canopy bottom 
cover counterclockwise (Figure 8).

Remove three of the six screws and lock 
washers (every other one) securing the 
reinforcing plate to the top of the fan motor 
housing (Figure 9).

3.

4.

Place the rubber gasket over the remaining 
three screws, route the wires exiting the top of 
the fan motor through the canopy ring (make 
sure the slot openings are on top). then proceed 
to place the ceiling canopy over the collar at 
the top of the motor. (Figure 10)

Align the mounting holes with the holes in the 
motor and fasten using the screws and lock 
washers removed in step 4 (Fig. 10).

Tighten the mounting screws security.

5.

6.

7.

Collar

Canopy 
Bottom 
Cover

Remove

Figure 8

Figure 9

Ceiling 
Canopy

Screw and 
Lock Washer
(3 Places)

Canopy Ring