GarrettCom 6K16 Manual De Usuario

Magnum 6K16-Series Managed Fiber Switch Installation and User Guide (04/06) 

 

43

.

.

All Magnum 6K16-Series units have address table capacities of 4K node 

addresses suitable for use in larger networks. They are self-learning, so as nodes are 

added, removed or moved from one segment to another, the 6K16-Series Switch 

automatically keeps up with node locations.   

An address-aging algorithm causes least-used addresses to fall out in favor of 

frequently-used addresses.  To reset the address buffer, cycle power down-and-up.  

PWR          :  Power LED, ON when external power is applied to the unit.  

 

LK             :   Steady ON, Link status for 10 Mbps and 100Mbps operation.   
ACT          :  ON with port activity for 10 Mbps and 100Mbps operation.  

 

F/H            :  Full / Half duplex LED, ON when the port is running full duplex, 

OFF for half duplex.  

100/10        : Speed LED, ON when the speed is 100Mbps , OFF when the     

speed is 10 Mbps  

The module has a manual Up-link switch, located on the inside of the board 

next to the 10/100Mb (6K8-RJ45) port # 1 which it controls.  It enables the port’s cable 

to be cascaded (X) to a 10/100Mb repeater or switching hub in the network. The Up-link 

Switch position is configured as (=) straight position by default from the factory settings 

on all the RJ-45 ports, either used for all copper module or combo module. 

Auto-Cross(MDIX) and Auto-negotiation, for RJ-45 ports 

 

The RJ-45 ports independently support auto-cross (MDI or MDIX) in 

auto-negotiation mode and will work properly with all the other connected devices 
with RJ-45 port whether it supports Auto-negotiation or not (e.g 10Mb Hub, media 
converter) or fixed mode at 10Mb or 100Mb Half/Full Duplex(managed switch). No 
cross-over cable is required while using the 6K8’s copper port to other devices. 
Operation is according to the IEEE 802.3u standard.  

The Managed 6K16-Series Fast Ethernet copper ports, can be set for either fixed 100Mb 

speed or for 10/100 F/H N-way auto-negotiation per the IEEE802.3u standard. The 

selection is made via MNS software.  The factory default setting is for auto-negotiation.  

At 10Mb or 100Mb-fixed speed, the user may select half- or full-duplex mode by MNS 

Software for each RJ-45 port separately. For detail information See Section (10.1 at