Hitachi NT50AGF Manual De Usuario

— 27 —

Once the Gate is removed, clear the jammed Nail.

Inspect to be sure no damage has been done to the Driver 

Blade, Guide, Gate, Magazine or Pusher Finger.  (If damage has 

occurred, repair immediately before connecting to the power 

source and continuing.)

Replace the Gate by placing the Gate over the two Screws in the 

Guide as shown and press down and upward to seat and lock 

the Gate in place as shown in Figure 2. When properly seated, 

the Gate should not slide down. Make sure the Gate is properly 

re seated and tighten the two Screws.

DO NOT OPERATE WITH THE GATE LOOSE OR REMOVED!

CAUTION NEVER pry on the Gate when trying to remove the 

Gate. Prying could cause breakage. ENSURE THAT THE GATE IS 

SECURE BEFORE CONTINUING OPERATION.

2. Resetting the Piston / Driver Blade

Disconnect from the Air source.

Unload all of the Nails from the Magazine.

Make sure there are no Nails in the Guide/Gate chamber.

Reconnect the Air source to the Nailer.

While squeezing the Safety Lever, push the Ram down and hold 

for three (3) seconds and release. 

Load Nails and proceed with the operation of the Nailer.

3. Inspecting the Magazine

DISCONNECT THE AIR HOSE

Clean the magazine. Remove dust or wooden tips which may 

have accumulated in the magazine.