FIELD CONTROLS UV-18 Manual De Usuario

 

Page 4

3.  Remove base unit and cover from box.  

4.  Apply supplied “Duct Seal Kit” according to instructions included in kit 

(See Figure 12) 

5.  Determine whether to use flat or angled bracket. (Refer to UV-Aire 

“Bulb Mounting Bracket Selection” in section IV for aid in this decision) 

a.  Flat Bracket Installation 

i. 

Remove the two hex nuts and flat bracket from included bagged 
hardware. 

ii. 

Install the flat bracket and secure to the unit base with the hex 
nuts provided. (See Figure 13) 

b.  Angled Bracket Installation 

NOTE:    For angled bracket mounting, refer to specifications outlined by 
Diagrams A & B for mounting distances in the “Angled Lamp Mounting 
Bracket Specifications” in section IV. 

i. 

Remove the two hex nuts and angled bracket from included 
bagged hardware. 

ii. 

Install the angled bracket and secure to the unit base with the hex 
nuts provided. (See Figure 14) 

NOTE:  Be sure to note location of lamp hole in bracket relative to 

unit base. 

6.  Mount the unit base to the duct using the four mounting screws provided. (See Figure 

15) 

7.  Remove tag and alcohol wipe from lamp. Wipe off lamp being sure not to touch lamp 

with bare hands. The oils from your hands will reduce lamp output. 

WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or
blindness.  Never operate the UV-Aire™ Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your
hands.