Genie H Manual De Usuario
3. Wiring.
•
Route wire (29) using either method shown
(Fig. 3-5).
(Fig. 3-5).
•
Wires along rail are held in place with wire clips.
–
Wires can be slipped under the wire clips
already in place.
already in place.
15
SAFE-T-BEAM
®
SYSTEM INSTALLATION
FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM
3
NOTE: The operator will not close the door
automatically unless the Safe-T-Beam
automatically unless the Safe-T-Beam
®
System is
installed.
1. Mounting brackets.
•
Mark both sides of garage door frame or wall 5"
above floor. (Fig. 3-1).
above floor. (Fig. 3-1).
•
Hold bracket against door frame or wall.
–
Check if brackets extend out from wall far
enough, so tongue of bracket is beyond door,
tracks or any door hardware.
enough, so tongue of bracket is beyond door,
tracks or any door hardware.
–
If not:
a. STB bracket extensions are available
a. STB bracket extensions are available
at local dealer.
b. Blocks of wood, etc. may be substituted for
extensions.
•
Center bracket on your mark (Fig. 3-2).
•
Fasten each with 2 screws (44) (Fig. 3-2).
NOTE: Mounting brackets can be attached to the
floor using concrete anchors (not provided).
floor using concrete anchors (not provided).
2. Mounting STB source and sensor.
•
If garage has only one garage door.
–
Determine which side of garage receives most
direct sunlight (Fig. 3-4).
direct sunlight (Fig. 3-4).
–
Red LED should always be on sunny side
whenever possible (Fig. 3-4).
whenever possible (Fig. 3-4).
•
For multiple doors.
–
Preventing crossed signals is critical.
–
Place source and sensor modules on adjacent
doors facing in opposite directions (Fig. 3-4).
doors facing in opposite directions (Fig. 3-4).
NOTE: To help prevent interference from sun, STB
sensors (Green LED) may be placed further away from
the door opening where they will spend more time
in shadows.
sensors (Green LED) may be placed further away from
the door opening where they will spend more time
in shadows.
•
Slide source/sensor onto tongue of bracket until
it clicks into place (Fig. 3-3).
it clicks into place (Fig. 3-3).
There should be no electrical power to the operator
while installing Safe-T-Beam System
while installing Safe-T-Beam System
®
wires. If you
have plugged in the power cord UNPLUG IT NOW.
WARNING
FIG. 3-1 Mark door frame
.
FIG. 3-2 Mount
brackets
brackets
.
FIG. 3-3 Attaching
STB’s to brackets
STB’s to brackets
.
[41]
FIG. 3-5 STB wiring methods
.
Sensor
Source
Red
Green
Power
Head
Head
Sensor
Source
Red
Green
Power
Head
Head
A
B
Dashed Line = striped wire
Solid Line = white wire
tongue
mark
center of
bracket
FIG. 3-4 STB locations
.
#10-16 x 1-1/4"
[44]
SUN
ONE DOOR
GARAGE
GARAGE
THREE DOOR
GARAGE
GARAGE
RED
LED
RED
LED
GREEN
LED
RED
LED
GREEN
LED
GREEN
LED
GREEN
LED
RED
LED
RED
LED
RED
LED
GREEN
LED
GREEN
LED
TWO DOOR
GARAGE
GARAGE