Genie SILENTMAX 1000/1200 Manual De Usuario

 

Need help or have questions? 

DO NOT RETURN to the store. Call us: 

• Check power source.

  –  Plug a lamp into outlet used for powerhead. If lamp works, power source is OK.

  –  If not, check fuse or circuit breaker.

• If power is OK,

  –  Check connections at powerhead terminals and at wall console.

  –  Limits must be set with door arm connected to door.

• Check if wall console Sure-Lock™ is ON. Turn Sure-Lock™ OFF and check operation.

• Check for reversed, broken or cut wires. Staples can cut insulation and short wires. Repair or replace.

• Make certain carriage is engaged into chain/belt bullet or screw drive shuttle. See page 6. Refer to Installation

poster or download poster from 

• Check to make sure chain/belt is not broken or OFF its pulley.

• Check all remotes.

• Replace remote battery with good one. See page 17.

• Program remote to powerhead. See pages 10-11.

• Relocate remote inside car and/or point remote at garage door.

• Replace battery. See page 17.

• Reposition door opener antenna.

• Remote LED does not come ON with button push – replace battery. See page 17.

• Eliminate possible competing signals (satellite radio, FiOS

®

 TV).

• If a NEW installation, check Door Arm position. Refer to Installation poster or download poster from  

• Check if limits are properly set. See pages 6-7.

• Check if Safe-T-Beam

®

 Red LED is flashing.

• Check Safe-T-Beam

®

 system for beam obstruction or misalignment of lenses.

• Check garage door for binding.

• If an operational problem exists, and opener will not close, the opener can be forced to close as follows: Press

  and hold the wall console button until door is completely closed.

• Check for interference from adjacent Safe-T-Beam

®

 units.

• Contact The Genie Company at 1-800-35GENIE.

• Check Safe-T-Beam

®

 wire connections at powerhead and at STBs. See page 8, STB instruction, poster or website.

• Check if limits are properly set. See pages 6-7.

• Check CONTACT REVERSE. See pages 8-9.

• Check garage door for binding.

• Check closing “FORCE” adjustment. See page 8.

• Check if limits are properly set. See pages 6-7.

• Be sure door, opener, and springs are in good repair, properly lubricated and balanced.

• Check closing “FORCE” adjustment. See page 8.

•   WARNING: If you suspect a problem with the garage door hardware or springs, contact  

The Genie Company at 1-800-35GENIE.

• Check if limits are properly set. See pages 6-7.

• Check Sure-Lock™. Sure-Lock™ should be OFF for normal operation. See page 8.

• Check door balance, condition, and door spring.

• Check opening “FORCE” adjustment. See page 8.

•   WARNING: If you suspect a problem with the garage door hardware or springs, contact  

The Genie Company at 1-800-35GENIE.

• Button stuck on wall console or remote.

• Was a remote lost or stolen? Erase all remotes from powerhead memory and program new remotes. See page 13.

G999-393 Manual-ScrewBeltChain-EN indd   21

7/13/12   10 17 AM