Genie SILENTMAX 1000/1200 Manual De Usuario

 

Reversing System
Puts an invisible beam across the door opening. 
The door stops and reverses to the full open 
position if anything passes through the beam. 
LED indicator lights on the powerhead and on 
the STBs provide a self-diagnostic code if an 
operational problem exists.

Automatically stops and reverses a closing door 
within two seconds of contact with an object.

Automatically sets the force required to fully 
open and close the door for maximum safety.

Monitors the Safe-T-Beam

®

 system to ensure 

proper functionality and will automatically stop 
and reverse a closing door if a problem  
is detected.

Manual Emergency Release
Manually releases door from door opener. Used 
during a power failure or other emergency to 
allow manual opening and closing of door.

SmartSet™ Electronic Programming
Easily adjust the programming to reduce  
opening speed to a desired rate, vary limits  
and force, and program new remotes.

Automatic Lighting System
Two bulb lighting system supplies light for safer 
evening exits and entries. Turns 

ON when door is 

activated and automatically turns 

OFF 4 minutes 

later.

Integrated Motion Detection (Not available on 

all models)

Some units have motion detection built into the 
powerhead. Lights automatically turn 

ON when 

motion is detected for much safer movement 
through the garage. Lights will turn 

OFF after  

4 minutes of no motion.

A new generation superior encryption system 
that enhances the security of the door opener 
by continuously changing the access code each 
time the remote is used. The door opener re-
sponds to each new code only once. An access 
code copied from a working system and tried 
again, will not control the door opener.

Wall Console
Operates door opener from inside garage.  
The wall console has an indicator light with: 
Open/Close, Sure-Lock

™

, and independent  

light control buttons.

Home Link and Car2U

®

 compatible. Refer to the 

programming instructions on page 11.

and installation of opener. Review Assembly/Installation  

Instructions poster. Check that all steps have been  

Contact your Genie® Professional Dealer for an  
Assembly/Installation Instructions poster, if needed,  

or call 1-800-35GENIE. You can also go to  
www.geniecompany.com to download a printable file.

Begin here ONLY AFTER completing assembly and installation of the opener. Review the Assembly and Installation poster to ensure all steps have 

been performed. 

Contact your Genie® Professional Dealer for an installation poster, if needed, or call 1-800-35GENIE. You may also visit www.geniecompany.com 
to download a PDF file.

1. The Safe-T-Beam

®

 has no effect on the door during an opening cycle.

2.  If the Safe-T-Beam

®

 detects an obstruction when trying to close the 

door, it will not allow the door to close.

3.   When the garage door is closing, if Safe-T-Beam

®

 is interrupted by  

a person or obstacle, the garage door will stop its downward travel 
and reverse automatically to its fully opened position.

4. If the Safe-T-Beam

®

 System fails, loses power, or is installed 

   improperly, press and hold the wall console “open/close” button  

until the door reaches its fully closed position. If you release the 
“open/close” button on the wall console during the 

closing  

movement, the door will reverse automatically to its fully-opened 
position.

G999-393 Manual-ScrewBeltChain-EN indd   4

7/13/12   10 17 AM