Lennox Hearth ELDV4035 Manual De Usuario

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

This log placement guide has been prepared to present detailed place-

ment illustrations and provide instruction to assist in the initial (new 

appliance) setup and after the annual cleaning and inspection cycles.  

The information provided here is to be used in conjunction with the 

Care and Operation Instructions provided together with this document 

in the appliance literature packet.  Please read the Care and Operation 

Instructions completely before completing the procedures detailed in 

this placement guide.

If the logs are being installed for the first time, the following para-

graphs apply:

DO NOT attempt to install the logs until the appliance installation 

has been completed, the gas line connected and tested for leaks and 

the initial burner operation has been checked out. 

Step .  Remove the appliance front door.

Step 2.  Cut and remove the nylon strapping securing the log set 

inside the fireplace.

Step 3.  Remove the logs from their packaging.  Handle logs care-

fully to prevent breakage.

Step .  Position the individual logs as shown in Figures 3, 4 and 5.  

Logs should be placed in the order shown.  

Step 2.  Separate the Glowing Ember (Rockwool) into pieces about 

the size of a nickel (see Figure 1).  Keep the pieces fluffed up with 

torn edges and not matted.  Distribute these pieces over the burner as 

shown in Figure 2.  Do not use more than necessary.  When properly 

positioned, the Glowing Embers will cover approximately 10% of the 

burner.  Do not place embers on main ports.

Step 3.  Place a mixture of volcanic stone and vermiculite around the 

burner as shown.  do not place the mixture on the burner.

Proper log and twig placement is critical to encourage outstanding 

flame appearance and prevent sooting.  

These fires are designed to provide a rich orange/red glow on the logs.  

Rear log (2) placement is critical.  An adjustment of one quarter of an 

inch can have significant effect on flame color and height.  Pull rear log 

(2) forward as far as it will go on the pins.