CarAlarms.com P90-NG1 Manual De Usuario

Excalibur

®

 P90 Zero Clearance Direct Vent Gas Fireplace

1)  Turn burner OFF using "ON/OFF" switch.

Only when the pilot holds, without pressure 
being applied to the control knob, resecure the 
glass panel to the unit. The unit must not be 
operated with the glass removed. 

1)  Read and understand these instructions 

before operating this appliance.

2)  Check to see that all wiring is correct and 

enclosed to prevent possible shock.

3)  Check to ensure there are no gas leaks.

4)  Make sure the glass in the door frame is 

properly positioned. Never operate the 
appliance with the glass removed.

5)  Verify that the venting and cap are 

unobstructed.

6)  Ensure that the brick panels are installed.

7)  Verify log placement. If the pilot cannot be 

seen when lighting the unit, the logs have 
been incorrectly positioned.

8)  The unit should never be turned off, and on 

again without a minimum of a 60 second 
wait.

2)  Turn gas control knob so indicator points 

to "OFF" position and allow 5 minutes for 
any gas in the combustion chamber to 
escape.

3)  Turn gas control knob counterclockwise 

so indicator points to the "PILOT" position. 
Depress the gas control knob fully. Depress 
the igniter button several times until the 
pilot lights. After approximately one minute, 
release the gas control knob. The pilot fl ame 
should continue to burn. If the pilot does not 
remain lit, repeat operation allowing a longer 
period before releasing gas control knob.

4)  When the pilot stays lit, turn the gas knob 

further counterclockwise to the "ON" 
position.

5)  Use the wall switch, thermostat or remote 

control to turn on the unit.

6)  Rotate the fl ame height regulator to adjust 

the fl ame height higher or lower.

1)  Use the wall switch, thermostat or remote 

control to turn off the main burner.

2)  Turn the main gas control clockwise to the 

"OFF" position to turn off the pilot.

3)  Turn off all electric power to appliance if 

service is to be performed. 

The fi rst fi re in your fi replace is part of the paint 
curing process. To ensure that the paint is 
properly cured, it is recommended that you burn 
your fi replace for at least four (4) hours the fi rst 
time before you use it with the fan on. 

When fi rst operated, the unit will release an odour 
caused by the curing of the paint, the burning 
off of any oils remaining from manufacturing. 
Smoke detectors in the house may go off at this 
time. Open a few windows to ventilate the room 
for a couple of hours. 

The glass panel may require cleaning after the 

unit has cooled down. 

 

The air shutter can be adjusted by moving the 
adjusting wire up or down. The wire is accessed 
through the bottom louver opening. Open the 
air shutter for a blue fl ame or close for a more 
yellow fl ame. The burner aeration is factory set 
but may need adjusting due to either the local 
gas supply or altitude.