Breckwell P24I Manual De Usuario

VERTICALLY WITH NEW CHIMNEY SYSTEM (Refer to 
Figure 9a & 9b) 

 
NOTE: Follow L-Vent chimney manufacturer’s instructions. 
 
OPTION:  To achieve a center vertical installation a 45º elbow and a 
clean-out tee can be used to offset the pipe from the exhaust outlet 
to the rear center of the stove (see figure 9a). You can also use the 
P24FS Vertical Install Kit (part # A-VIK) (see figure 9b). 
 
OPTION: Install L-Vent elbow in place of clean-out tee. Locate 
stove. Drop plumb bob to center of tee outlet, mark point on ceiling. 
Install ceiling support and L-Vent pipe per L-Vent manufacturer’s 
instructions. 
 
1. 

Always maintain 3” clearance from combustible materials. 
When passing through additional floors or ceilings, always 
install firestop spacer. 

 
2. 

After lining up for hole in roof, cut either around or square hole 
in roof, always 3” larger all the way around pipe. Install upper 
edge and sides of flashing under roofing materials, nail to the 
roof along upper edge. Do not nail lower edge. Seal nail heads 
with non-hardening waterproof mastic. 

 
3. 

Apply non-hardening, waterproof mastic where the storm collar 
will meet the vent and flashing. Slide storm collar down until it 
sits on the flashing. Seal and install cap. Mobile home 
installations must use a spark arrester.