Empire Comfort Systems VFCT25-3 Manual De Usuario

Page 10

16937-4-0806

LOG PLACEMENT

Every burner is shipped with a protective cover. This cover must 

be removed before log placement. 
The positioning of the logs is critical to the safe and clean operation 

of this heater. Sooting and other problems may result if the logs 

are not properly and firmly positioned in the appliance.
PROPER INSTALLATION SEQUENCE: 

1. Install the rear log behind the pilot assembly directly on the 

pins on each side of the rear log shield.

2. Install the front log in front of the grate. The log is located into 

a notch area in the front grate area.

Refer to Figure 8 for the following warning.

Warning: Failure to position the parts in accordance with this 

diagram or failure to use only parts specifically approved with 

this appliance may result in property damage or personal 

injury.

During initial operation of the new heater, burning logs will 

give off a paper burning smell and orange flames will be 

present. Simply open the windows for a few hours to vent the 

odor.

 

Figure 8

PLACEMENT OF GLOWING EMBERS (rock wool)

Provided with the log set is a small bag of glowing embers (rock 

wool) to be placed between logs on the flat metal surface of the 

burner.
Placement of the glowing embers (rock wool) is very individual 

and light coverage of the areas indicated will provide your best 

effects. We recommend separation of the rock wool by hand and 

make your coverage as light and fluffy as possible.
Place just enough rock wool on the burner to obtain the glow and 

a gold, yellow flame.

Do  not  place  rock  wool  over  large  ports  in  rear  portion  of 

burner.
Rock wool should not be placed in the area of the pilot assem-

bly.
Replacement  of  loose  material  (glowing  embers)  must  be 

purchased from Empire Comfort Systems, Inc. Application of 

excess loose material (glowing embers) may adversely  affect 

performance of the heater. WARNING: All previously applied 

loose material must be removed prior to reapplication.

Refer to Parts List, Page 22 to order loose material (rock wool).