Kambrook KOH105/KOH107/KOH11 Manual De Usuario

NOTE: Always secure the 

mounting plate between the 

last two fins at each end of the 

oil heater (Fig.2).

NOTE: Make sure that the castor 

wheels are positioned away 

from the centre of the heater to 

provide greater stability (Fig.2).

1.  Place the radiator body upside 

down on a soft surface to avoid 
damage to the heater. Make sure 
it is in a stable position and will 
not fall. 

2.  Place the mounting plate onto the 

base of the oil heater, between 
the last two fins at each end.

3.  Remove the wing nuts provided 

from the U bolt assembly.

 

 

4.  Hook the U bolt around the body 

section, joining the last two fins, 
and feed each end back up 
through the top of the mounting 
plate. Secure the U bolt to the 
mounting plate with the plastic 
wing nut provided.

5.  Repeat at the other end of  

the heater.

6.  Return the unit to an upright 

position, and it is now ready for use.

Always place the heater on a firm, 

level surface in a stable upright 

position and unwind the cord to its 

full length.
Ensure the Heat Setting switches are 

switched to ‘OFF’.
Plug the cord into a 230V or 240V 
power point and switch on.

NOTE: To avoid an electrical 

circuit overload, it is 

recommended that no other 

appliances are plugged into 

the same circuit as your heater, 

when it is in use.

All Kambrook oil heaters operate in 

manual heating mode only, except 

for the KOH111 and KOH111B models, 

which can also operate using the 

programmable timer. To operate 

using the programmable timer, see 

the ‘Setting the Programmable Timer’ 

section.
The oil heater has two switches, 

offering three heat settings.

LOW 

MED 

HIGH 

LOW

MED

HIGH

400W

600W

1000W

600W

900W

1500W

1000W

1400W

2400W

Remove any promotional material or 

packaging from the heater.
The oil heater requires a small amount 

of assembly before use. 

NOTE: Before operation, 

please make sure that the 

castor wheels  have been 

correctly fitted to the castor 

wheel mounting plate (for 

KOH105, KOH105B and KOH107 

only) and the castor wheel 

mounting plate is securely 

fitted to the body of the oil 

heater (all models).

1.  Unpack the castor wheels from 

the packaging and remove the 
nut, spring washer and flat washer 
from the castor wheel shaft.

2.  Unpack the castor wheel 

mounting plate from the 
packaging. Feed the castor 
wheel shaft upwards through the 
underside of the castor wheel 
mounting plate, and align the 
rectangular locator on the base 
of the castor wheel shaft with the 
slot on the mounting plate. The 
castor wheel shaft and mounting 
plate should fit together snuggly.

3.  Replace the flat washer and 

spring washer back on to the 
castor wheel shaft, over the top of 
the mounting bracket and secure 
tightly with the nut provided. The 
nut may need to be tightened 
with a spanner (Fig.1).