Hampton Direct H35-NG1 Manual De Usuario

42

Hampton

®

 H35 Direct Vent Freestanding Gas Stove

11) Carefully lift the burner tray assembly out.

If your valve requires maintenance or replace-
ment, use the following instructions:

1)  If optional fan is installed, disconnect power 

source to stove.

2)  Remove access panel.
 

3)  Disconnect gas line to stove.

4)  Disconnect 3/8" NPT pipe from 90

o

 elbow 

on valve.

5)   Disconnect the two (2) switch wires from 

valve.

6) Disconnect 

piezo 

wire.

7)  Lift off the Cast Top and lift out the front 

door.  

8)  Carefully remove the logs, embers and 

rockwool.

9)  Remove burner (see diagram below). 

12) To replace the burner tray assembly, simply 

reverse these instructions.  

13) Remove two (2) thermopile wires.

14) Remove thermocouple with a 9 mm (metric) 

wrench.

15) Remove pilot nut with an 11 mm wrench.

16) Remove valve to orifi ce nut with a 13/16" 

wrench.

17) Remove inlet pipe with pipe wrench. Note 

orientation of 90

o

 elbow.

18) Remove two (2) phillips head M5 screws on 

each side of the valve.

19)  Remove valve and remove gas out 90

o

 brass 

fi tting. Note orientation of fi tting.

1)  To install a new valve assembly, reverse 

instructions for removing valve.  See  as-
sembly steps 1-12.

2)  Check for leaks and manifold pressure. See 

Gas Pressure Test  instructions.

3)  To reinstall valve, reverse instructions for 

removing valve assembly, steps 13-19.

Note: Use a 
magnetic type 
screwdriver if possible.

10) Remove all 18 screws holding the burner 

tray assembly in place.

Reverse the above steps (1 - 4). Make sure the 
fan wires and the ground wire are reattached.