Desa (V)T32P SERIES Manual De Usuario

www.desatech.com

111986-01D

FIREPLACE

INSTALLATION

CHECK GAS TYPE

Use proper gas type for fireplace unit you are

installing. If your gas supply is not correct, do not

install fireplace. See retailer where you purchased

the fireplace for proper fireplace according to your

gas type or to purchase gas conversion kit (see Ac-

cessories, page 36). A conversion kit is supplied

with the CHDV32NR.

INSTALLING OPTIONAL BLOWER
ACCESSORIES

NOTICE: If installing blower in

an existing fireplace with gas

connections, shut off gas sup-

ply and disconnect heater from

gas supply. Contact a qualified

service person to do this.

WARNING: If there is a duplex

electrical outlet installed in the

right side of the bottom of the

fireplace base area, be sure that

the electrical power to the outlet is

turned off before proceeding with

blower installation. Failure to do

this may result in serious injury.

Model BK Installation

Follow all instructions provided in blower ac-

cessory kit.

1. Attach the power cord to blower motor by

firmly pushing two female terminals at end

of power cord onto two spade terminals on

blower motor (see Figure 25).

2. Attach green ground wire from power cord

to blower housing using screw provided (see

Figure 25). Tighten screws securely.

3. Place blower against lower rear wall of firebox

outer wrapper with exhaust port directed up-

ward. The blower will fit inside back opening

and be held in position against back wall by

magnets (see Figure 25).

4. Be certain that all wire terminals are securely

attached to terminals on blower motor and

screw retaining green ground wire is tight.

5. Mount speed control box to switch bracket by

placing plastic control shaft forward through

opening in switch bracket (see Figure 26).

6. While supporting speed control, secure control

shaft with lock nut by pushing and turning

lock nut with pliers clockwise until it is tight

against front panel. Place control knob pro-

vided on shaft.

7. Turn on power to duplex outlet if previously

turned off per the warning in column 1.

8. Plug in blower power cord.

a. If your firebox is installed as a freestanding

unit with an accessory mantel, determine

whether power cord will exit left side or

right side of firebox. Route power cord

through exit hole and plug power cord into

a wall receptacle near firebox.

b. If your firebox installation is recessed

and/or pre-wired, plug power cord into

duplex outlet provided. Refer to your

firebox owner’s manual for instructions

on wiring duplex outlet.

CAUTION: Never touch the

blower wheel while in operation.

Figure 25 - Blower Model BK

Green
Ground Wire

Screw

Spade
Terminals

Magnetic
Strips

Exhaust
Port

Side View

Lower Firebox

Cavity

Blower
Location

Figure 26 - Attaching Speed Control to

Firebox

Switch
Bracket

Locknut

Control
Shaft

Control
Knob

Speed
Control

Blower
Plug-In

Duplex Outlet
(Located under-
neath firebox floor
against lower right
outside wall)