Friedrich ZQ10 A10B Manual De Usuario

Step 1. Slide the air conditioner into the case. Reinstall the

2 screws removed earlier on each side of the case.

Step 2. Before installing the front grille, pull out 

the vent control lever located above the unit control
knobs, as shown.

Step 3. Attach the front grille to the case by inserting the

tabs on the grille into the slots on the front of the
case. Push the grille in until it snaps into place.

When you detach the front grille from the case, push the
grille to your right side and pull it toward you.

Step 4. Lift the inlet grille and secure the front grille with a

type A screw. Lower the inlet grille into place.

The Friedrich ZQ08A10A has a reversible grille. The grille is
designed to open from both the top and the bottom.
To reverse the grille opening, you must follow the following
steps;
Step 1. Pull the entire grill of the front of the unit and locate

the hinges that hold the grille in place on the inside
of the grille.

Step 2. Insert the tip of a flat screwdriver in between one of

the Hinges and the ball shaped bearing of the grille.

Step 3. Very carefully pull the bearing out of the socket of

the Hinge and repeat steps 1-3 for the remaining
hinge and socket.

Step 4. Locate the top hinges on the grille.
Step 5. Turn the grille upside down and using flat

screwdriver, create an opening on the top hinge and
insert the ball shaped bearing to snap the grille in
place. Repeat the same steps on the remaining
hinge.

—16—

Inlet Grille

Power Cord

Screw

Screw