Friedrich WE10 Manual De Usuario

5

920-007-13

72

2

3

4

8

9

10 11 12

13

1

6

5

7

2

3

4

10 11 12

14

1

6

5

7

9

8

13

72

WS Model cool-only control panel

WY/WE Model heat-cool control panel

Automatic component protection

Your unit is equipped with Automatic Component Protection.  

To protect the compressor of the unit, there is a three minute delay 
if you turn the unit off or if power is interrupted. The fan will not be 
affected. Also, if you switch from Cool mode to Fan Only mode, and 
switch back to Cool mode, there is a three-minute delay before the 
compressor comes back on.

Using the remote control

To start unit

1  POWER - Press the Power button once. The unit will automatically 

start in the mode and fan speed it was last left on.

To set mode of operation

2   COOL - Press the Cool button to automatically switch the operat-

ing mode to COOL.

3  FAN ONLY - Press the Fan Only button if you want to run the 

fan only. 

4   HEAT  (WY/WE models only) - Press the Heat button to 

automatically switch the operating mode to HEAT.

5  MoneySaver

 - Press the Money Saver

 button to activate 

the MoneySaver

®

 feature. This feature cycles the fan with the 

compressor so that the fan does not run all the time.

To adjust temperature

6  WARMER - Press the    Warmer  button to raise the temperature setting.

7  COOLER -  Press the    Cooler  button to lower the temperature setting.

To adjust fan speed

8  FAN SPEED - Press the Fan Speed button to see the current 

setting.  Press again to change the fan speed.  F1 is the lowest 
setting (SLEEP / LOW), F2 is MEDIUM, F3 is HIGH, and SF is 
the SMART FAN setting.

To set the hour clock

9  SET HOUR CLOCK -  Press the Set Hr. button once to see the 

current clock setting.  Continue pressing the button until you 
arrive at the current time (Hour only).  Minutes are not shown on 
the display.  Make sure that the A.M. / P.M. setting is correct.