Crown Boiler BWC151 Manual De Usuario

Descargar
Página de 81
A.
C.
B.
D.

1.
6.
2.
7.
3.
4.
8.
9.
5.
10.
11.
12.
1.
3.
2.
4.
FOR YOUR SAFETY READ BEFORE LIGHTING
This appliance does not have a pilot.  It is 
equipped with an ignition device which 
automatically lights the burner.  Do not try 
to light the burner by hand.
Do not touch any electric switch; do 
not use any phone in your building.
If you cannot reach your gas supplier, call the 
fire department.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
WARNING:  If you do not follow these instructions exactly, a fire or explosion may 
result causing property damage, personal injury or loss of life.
Immediately call your gas supplier 
from a neighbor's phone.  Follow the 
gas supplier's instructions.
Use only your hand to turn the gas control knob.
Never use tools.  If the knob will not push in or turn by 
hand, don't try to repair it, call a qualified service 
technician.  Force or attempted repair may result in a 
fire or explosion.
Do not use this appliance if any part has been under 
water.  Immediately call a qualified service technician 
to inspect the appliance and to replace any part of the 
control system and any gas control which has been 
under water.
OPERATING INSTRUCTIONS
BEFORE OPERATING smell all around the 
appliance area for gas.  Be sure to smell 
next to the floor because some gas is 
heavier than air and will settle on the floor.
STOP!  Read the safety information above on 
this label.
Set the thermostat to the lowest setting.
Turn off all electric power to the appliance.
This appliance is equipped with an ignition 
device which automatically lights the burner.
Do not try to light the burner by hand.
Remove the front door panel and the upper 
boiler access panel.
Replace the upper boiler access panel and the front 
door panel.
TO TURN OFF GAS TO THE APPLIANCE
Smell for gas in the boiler enclosure.  If you smell gas, 
STOP!  Follow "B" in the safety information above.  If 
you don't smell gas, go to the next step.
Turn on all electric power to the appliance.
Set the thermostat to the desired setting.
The first digit of the control display panel will 
show a series of numbers that indicate the boiler 
control sequence.  The number 3 or 4 means the 
burner is firing.  The number 0 means there is no 
call for heat from the thermostat or the domestic 
water heater. 
Turn off all electric power to the appliance if 
service is to be performed.
Set the thermostat to the lowest setting.
Turn the external boiler manual gas valve T-
handle counterclockwise to open gas supply.
Turn the external boiler manual gas valve T-
handle clockwise to close the gas supply.
Replace the upper boiler access panel and the front 
door panel.
If the appliance will not operate, follow the 
instructions "To Turn Off Gas To Appliance" below 
and call your service technician or gas supplier.
59
BWC Series Lighting and Operating Instructions