Lopi 1750 Manual De Usuario

© Travis Industries

100-01179

4060926

NOTE:
Direct connections require
installation of an airtight,
non-combustible block-off
plate or damper adapter.

AAA

AAA

AAA

AAA

AAA

AAA

AAA

AAA

AA

AA

AA

AA

AA

AA

Block-off plate or 
damper adapter 

Remove damper 
or wire it open

Airtight 
Insulated 
Clean-Out

Stainless steel 
chimney connector 
must Extend 1' past 
the block-off plate or 
to the flue liner  

NOTE: The chimney must have a clay 
tile liner.  If it does not, the installation 
must use a positive connection (full 
reline).  The entire fireplace and 
chimney must be clean, undamaged, 
and meet all local building codes (UBC, 
etc.).  Damage must be repaired prior 
to installation.  The chimney must be 
15' to 33' tall.

Clay 
Liner

Floor Protection
(See the section 
"Floor Protection 
Requirements" for 
more details)

Combustible Mantle

Min. 18" 

See the section 
"Stove Placement 
Requirements" for 
minimum clearances 
required.

Max. 8”

NOTE:
This type of installation
requires a UBC approved
masonry connector or
other method approved by
the NFPA 211 standard.
See Chimney Connector
Requirements on page 10
for further details.

Make sure the 
clean-out seals in 
place.

Clay Liner

See the section "Stove 
Placement Requirements" for 
minimum clearances required.

Min. 18" 
clearance 
to ceiling

This type of 
installation requires 
a UBC approved 
masonry connector 
or a factory built 
(U.L. Listed) wall 
thimble.

Chimney connector sections

NOTE: The chimney must have a 
clay tile liner.  If it does not, the 
installation must use a positive 
connection (full reline).  The 
entire fireplace and chimney must 
be clean, undamaged, and meet 
all local building codes (UBC, 
etc.).  Damage must be repaired 
prior to installation.  The chimney 
must be 15' to 33' tall.

See the section 
"Floor Protection 
Requirements"