Avalon Stoves 700 B-VENT Manual De Usuario

Raise the stove 8" (use lumber or other sturdy device).  Attach each leg following the instructions below.

Attach each leg to the stove by 
inserting a bolt and washer through the 
hole or slot in the leg and into the 
threaded hole on the stove.

9/16" Socket Wrench

These rubber-tipped bolts are for leveling the stove.  
Make sure they contact the floor.  Do not adjust 
with weight on the legs, the rubber tips may tear.

The dowels insert onto the front and 
back edge of the pedestal base.

Use a 9/16" wrench to attach the two 
pedestal bolts to the bottom of the stove.

Pedestal 

The lag bolts 
and washers 
may be inserted 
through the 
holes in the 
base of the 
pedestal to 
anchor the 
pedestal to the 
floor (required 
for mobile 
homes).

AAAA

AAAA

AAAA

The cover plates, screen, 
insulation, and staples are used for 
wood stoves - discard these items.

AA

AA

AA

AA

AA

9/16" Socket Wrench

Stove

The telescoping legs are designed to support the front end of inserts on raised hearths.  It is adjustable
from 4 5/8" to 7 1/2".  It can be cut shorter by using a hacksaw (see the illustration below).

If the telescoping leg needs to be less than 4 5/8", unscrew the 
lower leg and shorten each leg with a hack saw.  The upper 
segment has a threaded rod inside.  Do not damage this rod 
while shortening the upper segment.

NOTE: The total length removed will equal the amount cut off of
both segments combined.  

A

AA

End Cap

A     Insert the end cap into the lower leg
B     Thread the upper and lower leg together.
C     Thread the bolt on the top leg into the front corners of the insert.
D     Adjust the lower leg down until it contacts the hearth.

Upper Leg

Lower Leg