Chief Manufacturing PLP Series Manual De Usuario

Installation Instructions

PLP Series

8

To tilt the display 0

°

 to 15

°

 down, do the following:

1. Manually tilt the display 0

°

 to 15

°

 down into the

desired position.

2. If desired, tighten the nut (see Figure 10) to increase

the amount of tension needed to hold the mount in
the position set in Step 1.

NOTE:Tighten the nuts only to adjust the amount of

tension needed to manually tilt and hold the
mount in place. Do not over-tighten the nuts.
Over-tightening the nuts may cause excessive
wear and may damage your mount.

3. Repeat Steps 1 and 2 until the desired tension is

obtained.

To install or remove cables, do the following:

1. Manually tilt display down slightly (see Figure 10),

and then pull bottom of display out (see Figure 11).

2. Lower center support bar to keep the display tilted up

(see Figure 12).

3. Perform service. For example: Connect or disconnect

the power/audio/video cables.

NOTE:The service position is not recommended as a

final display position.

4. Raise the center support bar and reposition the

display to desired position (if necessary, refer to
“TILT ADJUSTMENT” procedure) after service is
completed.

WARNING: Watch for pinch points. Do not put your

fingers between moveable parts.

0

°

15

°

Center
support bar

Tilt the display
 0

°

 to 8

°

 to connect

or disconnect cables.

0

°

8

°

1. Tilt display down

(see Fig. 10)

2. Pull bottom out

(See Fig. 11)

3. Lower support bar.
4. Perform service.
5. Return display to

desired position.

1. Adjust pitch
2. If necessary, tighten

nut slightly to
increase tension.