Dometic 3200 Series Manual De Usuario

0

1.  Toilet emits odor (flush ball 

open).

2.  Water will not stay in bowl.

3.  Water will not enter bowl.

4.  Water will not shut off and 

overflows bowl.

5.  Flush ball will not open.

6.  Hand spray unit leaks.

7.  Water does not enter toilet 

bowl properly. 

 

 

 

 

8.  Water leaking from water 

valve. 

 

 

 

 

9.  Water leaking from under  

toilet.

a.  Odor emitting from base of toilet.

b.  Plugged holding tank vent line.

a.  Improper seal between flush ball 

and seal due to dirt or debris on 

underside of flush ball seal.

b.  Worn or damaged flush ball and 

seal. 

a.  Water valve fuse is blown.

b.  Water valve filter screen is 

clogged.

c.  Defective water valve.

d.  Defective flush switch.

a.  Dirt or debris lodged in water 

valve seal.

b.  Defective water valve.

a.  Flush cable is loose or broken.

b.  Base pulley broken.

a. Hand sprayer is defective. 

a. Insufficient water flow rate at toilet.

b. Water valve clogged.

c. Plugged rim wash holes in toilet.

a.  Water valve body cracked due to 

freeze damage.

b.  Water line connection is loose or 

not seated properly.

c.  Defective water valve.

d.  Stripped threads.

a.  Toilet loose.

b.  Defective component under china 

bowl: vacuum breaker assembly, 

water hose/fittings, water valve 

assembly, upper bowl seal, base 

O-ring, rotor shaft, or plastic base.

c.  Worn or defective floor flange 

seal.

d.  Cracked china bowl.

a. Use SeaLand brand deodorants.

b. Clear obstructions from vent line.

a. Clean underside of flush ball seal 

(see cleaning method on page 7).

b. Remove toilet from floor,  

disassemble bowl from base and 

replace flush ball and seal. 

a. Replace fuse located in fuse panel.

b. Clean filter screen.

c. Replace water valve.

d. Replace flush switch.

a. Disassemble and clean water 

valve.

b. Replace water valve.

a. Tighten or replace cable.

b. Replace base pulley.

a. Replace hand sprayer. 

a. Check water flow rate at toilet. 

Rate should be 2 gpm (7.6 lpm)  

at toilet.

b. Remove and clean screen located 

at inlet of water valve.

c. Clean holes. If still a problem, 

replace the toilet bowl.

a. Replace water valve.

b. Insure that threads are not  

cross-threaded and tighten.

c. Replace water valve.

d. Replace water valve.

a. Tighten toilet mounting bolts.

b. Remove floor bolts and turn toilet 

to one side as much as possible, 

keeping telescoping base in floor 

flange adapter. Flush toilet to 

find source of leak. Tighten loose 

connections or replace defective 

component.

c. Replace seal.

d. Replace china toilet.