Kidde SL177i Prospecto
1394 South Third Street, Mebane NC 27302
1-800-880-6788 • www.kiddeus.com
1-800-880-6788 • www.kiddeus.com
Architectural and Engineering
Specifications
Specifications
The strobe light shall be Kidde Unit SL177i or approved
equal. It shall be powered by a 120VAC, 60Hz source. The
temperature operation range shall be between 40°F and
100°F (4°C and 38°C). The strobe light can be installed on
any standard single gang electrical box, up to a 4” octagon
junction box. The electrical connection (to the alarm) shall be
made with a plug-in connector. A maximum of 24 Kidde
devices can be interconnected in a multiple station arrange-
ment. The interconnect system must not exceed the NFPA
(National Fire Protection Association) limit of 18 initiating
devices (Smoke, heat, CO, etc) interconnected, it is still possi-
ble to interconnect 6 strobe lights and or relay modules. The
alarm shall provide optional tamper resistance that deters
removal of the unit from the wall or ceiling.
equal. It shall be powered by a 120VAC, 60Hz source. The
temperature operation range shall be between 40°F and
100°F (4°C and 38°C). The strobe light can be installed on
any standard single gang electrical box, up to a 4” octagon
junction box. The electrical connection (to the alarm) shall be
made with a plug-in connector. A maximum of 24 Kidde
devices can be interconnected in a multiple station arrange-
ment. The interconnect system must not exceed the NFPA
(National Fire Protection Association) limit of 18 initiating
devices (Smoke, heat, CO, etc) interconnected, it is still possi-
ble to interconnect 6 strobe lights and or relay modules. The
alarm shall provide optional tamper resistance that deters
removal of the unit from the wall or ceiling.
This unit shall include a bright candela strobe light with a
flash rate of one (1) flash per second. This unit shall be
interconnected with Kidde smoke alarms, heat detectors
and/or carbon monoxide alarms. The unit shall at a minimum
meet the requirements of UL217, NFPA72, (chapter 10 & 11
2002 edition) The State of California Fire Marshall, NFPA101
(One and two family dwellings, Federal Housing Authority
(FHA), Housing and Urban Development (HUD), Americans
with Disabilities Act (ADA).
interconnected with Kidde smoke alarms, heat detectors
and/or carbon monoxide alarms. The unit shall at a minimum
meet the requirements of UL217, NFPA72, (chapter 10 & 11
2002 edition) The State of California Fire Marshall, NFPA101
(One and two family dwellings, Federal Housing Authority
(FHA), Housing and Urban Development (HUD), Americans
with Disabilities Act (ADA).
Installation of Strobe Light
The strobe light should be installed to comply with all local
codes having jurisdiction in your area, Article 760 of the
National Electric Code, and NFPA 72. Make certain all alarms are
wired to a single, continuous (non-switched) power line, which
is not protected by a ground fault interrupter. A maximum of
1000 ft. of wire can be used in the interconnect system.
codes having jurisdiction in your area, Article 760 of the
National Electric Code, and NFPA 72. Make certain all alarms are
wired to a single, continuous (non-switched) power line, which
is not protected by a ground fault interrupter. A maximum of
1000 ft. of wire can be used in the interconnect system.
120VAC Dual Mode Strobe Light
for the Hearing Impaired
for the Hearing Impaired
Unit Number SL177i
Technical Specifications
Unit Number:
SL177i
UPC:
0-25417-19129-5
Power Source:
120VAC, 60HZ
Temperature Range: 40˚F to 100˚F (4˚C to 38˚C)
Size:
5.6” in diameter x 3” depth
Weight:
1lb
Interconnects:
Up to 24 Kidde devices
Warranty:
5 year limited warranty
Distributed by:
Ordering Information
Gift Box UPC: 0-25417-19129-5
Part
Dimensions
Case/
Layers/
Skid
Number
I 2 of 5
Pack Quantity
(w x d x h inches)
Weight
Skid
Skid
Weight
SL177i
N/A
Individual
5.75 x 3.25 x 6.75
1lb
N/A
N/A
N/A
SL177i
200 25417 19129 9
3 units
6.5 x 10.5 x 6.5
3lbs
120
5
360lbs
5.6"
3"