Runco SC-35d Manual De Usuario
Runco SC-30d/SC-35d Installation/Operation Manual
11
PRE
L
Y
Rear Panel Layout
Figure 2-5 shows the rear connector panel on the Dimension Digital Controller.
Figure 2-5. DC-300 Dimension Digital Controller Rear Panel
1.
MAIN POWER SWITCH
Disconnects or applies power to the Dimension Digital Controller.
Disconnects or applies power to the Dimension Digital Controller.
2.
3D Sync Out
A 3-pin, VESA standard mini-DIN connector for connecting the Runco Active 3D
Emitter to the Dimension Digital Controller (see Figure 3-25).
A 3-pin, VESA standard mini-DIN connector for connecting the Runco Active 3D
Emitter to the Dimension Digital Controller (see Figure 3-25).
3.
TRIGGERS
Connection for up to three (3), 12-volt trigger-controlled devices such as retractable
screens or screen masks. Output current is limited to 250 milliamperes (mA).
Connection for up to three (3), 12-volt trigger-controlled devices such as retractable
screens or screen masks. Output current is limited to 250 milliamperes (mA).
4.
USB
A standard, USB Series “B” connection to a personal computer, for performing
software upgrades and other service procedures.
A standard, USB Series “B” connection to a personal computer, for performing
software upgrades and other service procedures.
5.
RS-232 (To Accessory Box)
Reserved for future use.
Reserved for future use.
6.
Pri. Display Control
Connect this to the RS-232 input on the projector.
Connect this to the RS-232 input on the projector.
7.
Sec. Display Control
Not used.
Not used.
8.
IR
Wired input from a Niles- or Xantech-compatible, infrared (IR) repeater system. It is a
3.5-mm, mini phono jack, wired as follows:
Ring = No connection
Tip = IR Input
Sleeve = Ground
Wired input from a Niles- or Xantech-compatible, infrared (IR) repeater system. It is a
3.5-mm, mini phono jack, wired as follows:
Ring = No connection
Tip = IR Input
Sleeve = Ground
9.
RS-232 (PC / Control)
A female, 9-pin D-sub connector for interfacing with a PC or automation/control
system.
A female, 9-pin D-sub connector for interfacing with a PC or automation/control
system.
10. POWER INPUT (100 to 240 VAC)
Connect the Dimension Digital Controller to power here.
USB
To Accessory Box
Video 1
Y
Video 2
Video 3
Pr
Pb
PC / Control
RS-232
IR
Pri. Display Control
Sec. Display Control
HDMI 2
HDMI 4
HDMI 6
HDMI 8
Ethernet
HDMI Out
To Sec. Display
HDMI Out
To Pri. Display
HDMI Out
Audio Only
Component / SCART
TRIGGERS
RS-232
1
2
3
3D SYNC
HD2
DisplayPort
Y
Pr
Pb
Compone
19
16
11
10
8
3
9
6
7
5
4
HD2
12
13
18
17
14
Video 1
Video 2
Video 3
ent / SCART
ne
1
2
HDMI 2
HDMI 4
HDMI 6
HDMI 8
15