Runco SC-30d Manual De Usuario
92
Runco SC-30d/SC-35d Installation/Operation Manual
PRE
L
IMINAR
Y
when and to whom the Dimension Digital Controller sends error and service notification
messages via e-mail.
messages via e-mail.
The notification messages are in the following format:
To: [E-Mail Address; see below]
From: do-not-reply@runco.com
Subject: [Type of notification] from Runco DC-300
Body:
From: do-not-reply@runco.com
Subject: [Type of notification] from Runco DC-300
Body:
This is an automated message sent from the Runco DC-300:
Notification:
[One of the following:
“DC-300 Error” / “Display Error”
“Periodic Service Notification”
“Lamp Life Notification” / “Calibration Data”]
“DC-300 Error” / “Display Error”
“Periodic Service Notification”
“Lamp Life Notification” / “Calibration Data”]
Detailed Description: [ If a DC-300 Error, one of the following:
“Fan Failure 1” / “Fan Failure 2”
“Overtemp 1” / “Overtemp 2”
“Initialization Failure”
“Overtemp 1” / “Overtemp 2”
“Initialization Failure”
If a Display Error, a device-specific
error message such as “Lamp Door Open”
error message such as “Lamp Door Open”
If a Periodic Service Notification, the elapsed
time since the last notification
time since the last notification
If a Lamp Life Notification, the number of hours
the lamp has been in service
the lamp has been in service
If a Calibration Data message,
“See Attached File” ]
“See Attached File” ]
Serial Number:
[Dimension Digital Controller serial number]
Customer Information: [From “Customer Information“ sub-menu;
see below]
Best Regards,
Runco International, LLC
1195 NW Compton Drive
Beaverton, OR 97006
1-800-237-8262
1195 NW Compton Drive
Beaverton, OR 97006
1-800-237-8262
• E-Mail Address: To specify the destination e-mail address for error and service
notifications, select E-Mail Address from the E-Mail Notification menu. The
procedure is similar to that for setting the IP address (refer to IP Configuration on
page 90). Enter up to 45 alphanumeric characters.
procedure is similar to that for setting the IP address (refer to IP Configuration on
page 90). Enter up to 45 alphanumeric characters.
• Error Notification: To have the Dimension Digital Controller send a message to the
destination e-mail address when a “DC-300 Error” or “Display Error” occurs, select
Error Notification from the E-Mail Notification menu and set it to On.
Error Notification from the E-Mail Notification menu and set it to On.
• Error Notification to Runco: To have the Dimension Digital Controller send an
e-mail message to Runco Customer Support when a “DC-300 Error” or “Display
Error” occurs, select Error Notification to Runco from the E-Mail Notification menu
and set it to On.
Error” occurs, select Error Notification to Runco from the E-Mail Notification menu
and set it to On.