Runco SC-60D Manual De Usuario
Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
73
PRE
L
IMINAR
Y
when and to whom the DHD Controller sends error and service notification messages
via e-mail.
via e-mail.
The notification messages are in the following format:
To: [E-Mail Address; see below]
From: do-not-reply@runco.com
Subject: [Type of notification] from Runco DHD4
Body:
From: do-not-reply@runco.com
Subject: [Type of notification] from Runco DHD4
Body:
This is an automated message sent from the Runco DHD4:
Notification:
[One of the following:
“DHD Error” / “Display Error”
“Periodic Service Notification”
“Lamp Life Notification” / “Calibration Data”]
“DHD Error” / “Display Error”
“Periodic Service Notification”
“Lamp Life Notification” / “Calibration Data”]
Detailed Description: [ If a DHD Error, one of the following:
“Fan Failure 1” / “Fan Failure 2”
“Overtemp 1” / “Overtemp 2”
“Initialization Failure”
“Overtemp 1” / “Overtemp 2”
“Initialization Failure”
If a Display Error, a device-specific
error message such as “Lamp Door Open”
error message such as “Lamp Door Open”
If a Periodic Service Notification, the elapsed
time since the last notification
time since the last notification
If a Lamp Life Notification, the number of hours
the lamp has been in service
the lamp has been in service
If a Calibration Data message,
“See Attached File” ]
“See Attached File” ]
Serial Number:
[DHD Controller serial number]
Customer Information: [From “Customer Information“ sub-menu;
see below]
Best Regards,
Runco International, LLC
1195 NW Compton Drive
Beaverton, OR 97006
1-800-237-8262
1195 NW Compton Drive
Beaverton, OR 97006
1-800-237-8262
• E-Mail Address: To specify the destination e-mail address for error and service
notifications, select E-Mail Address from the E-Mail Notification menu. The
procedure is similar to that for setting the IP address (refer to IP Configuration on
page 71). Enter up to 45 alphanumeric characters.
procedure is similar to that for setting the IP address (refer to IP Configuration on
page 71). Enter up to 45 alphanumeric characters.
• Error Notification: To have the DHD Controller send a message to the destination
e-mail address when a “DHD Error” or “Display Error” occurs, select Error
Notification from the E-Mail Notification menu and set it to On.
Notification from the E-Mail Notification menu and set it to On.
• Error Notification to Runco: To have the DHD Controller send an e-mail message
to Runco Customer Support when a “DHD Error” or “Display Error” occurs, select
Error Notification to Runco from the E-Mail Notification menu and set it to On.
Error Notification to Runco from the E-Mail Notification menu and set it to On.