HP (Hewlett-Packard) 2000491 Manual De Usuario

Find the description that most closely matches your problem, and try the corresponding solution.

■

Check that the correct input source is selected on the TV.

■

Check that the TV is connected to the HP Digital Entertainment Center. See “Video 
Out to TV” on page 67.

■

Check that the TV Out image is enabled. See “Configuring Video” on page 135.

■

If the Video Output S-video and composite connections are not connected to a TV 
or Video Input when the HP Digital Entertainment Center is turned on, the S-video 
and composite jacks will turn off automatically. You must turn off, by pressing and 
holding down the On/Standby (power) button for 4 seconds, and restart your 
HP Digital Entertainment Center to ensure Video Out connection to your TV or AV 
receiver.

■

Check your input switches.

■

Refer to http://www.hp.com/support for additional information on 
adjusting the display or updating the drivers. 

■

If you see a blank screen, you cannot perform recovery or certain activities with 
DVI. Change your Video Out connection to VGA or S-video, recover your system, 
and then reconnect the DVI connection.

■

Connect a monitor to your HP Digital Entertainment Center. See “Video Out to TV 
and Monitor” on page 72. 

If your TV is connected with S-video or composite video out connection, the screen 
may flicker/flash during power-on to windows desktop process. Wait; the screen 
should display normally after the desktop displays.