HP (Hewlett-Packard) 2000491 Manual De Usuario

You can use the HP Digital Entertainment Center remote 
control to change channels and adjust volume if you have 
a cable box or satellite receiver, have installed the 
Infrared Transmitter cable, and have configured the 
remote control after initial turn on.

Always point the HP Digital Entertainment Center remote 
control at the HP Digital Entertainment Center front panel. 
The infrared remote sensor, behind the front panel 
window, receives signals from the remote control.

The HP Digital Entertainment Center includes one or two 
Infrared Transmitter cables (IR blaster) that are required to 
control one or two set-top boxes. You must carefully 
position the Infrared Transmitter cable tip on the set-top 
box to ensure the set-top box receives the IR signal from 
the HP Digital Entertainment Center. See “Infrared 
Transmitter Installation” on page 92.

The supplied SCART adapter enables you to connect the 
composite video output of your HP Digital Entertainment 
Center to TVs that only accept a 20-pin SCART input.

In addition to the composite video input, the SCART 
adapter enables you to connect left and right channel 
audio signals to your TV.

The SCART adapter is shown in the following graphic.

.