Compatible Systems 2 Manual De Usuario
Chapter 3 - Network Installation
9
Chapter 3 - Network Installation
Figure 1. IntraPort 2/2+ VPN Access Server Back Panel
This section of the manual describes how to connect the IntraPort 2/2+
VPN Access Server to your Ethernet network. In summary, the steps for
installation are:
VPN Access Server to your Ethernet network. In summary, the steps for
installation are:
1.
Make sure the server is powered down and not connected to any
power source.
power source.
2.
Connect the server to the Ethernet network(s).
3.
Connect a management console to the server (optional).
4.
Plug in the power cable and power up the server.
Placing the Server
The IntraPort 2/2+ VPN Access Servers are meant to be left stand-alone
on a desktop or equipment table.
on a desktop or equipment table.
v Note: When stacking other equipment on the IntraPort 2/2+, do not
exceed 25 pounds of evenly distributed weight on top of the device.
Additional weight may bend the case.
Additional weight may bend the case.
Connecting the Server to the Ethernet
Because Ethernet 1 is IPSec-only (meaning it will only handle IPSec
packets and will drop all other traffic), you need to pay special attention
to your Ethernet connection setup.
packets and will drop all other traffic), you need to pay special attention
to your Ethernet connection setup.
Ethernet 1 should only be used if you are planning to set the IntraPort
2/2+ to operate in parallel with your existing firewall. This is the recom-
mended setup. In this scenario, Ethernet 1 should be connected to the
same Ethernet segment as your Internet gateway router while Ethernet 0
will serve as an IP, IPX and AppleTalk router port for your internal
networks.
2/2+ to operate in parallel with your existing firewall. This is the recom-
mended setup. In this scenario, Ethernet 1 should be connected to the
same Ethernet segment as your Internet gateway router while Ethernet 0
will serve as an IP, IPX and AppleTalk router port for your internal
networks.