Sanitaire S647 Series Manual De Usuario

Descargar
Página de 7
5
Micron Filter
®
 Bag Care 
(Micron Filter Bag is standard on some models)
Because the Micron Filter Bag is an effective fi lter medium, 
occasionally trapped dust particles will need to be cleaned 
from the inside of it. The dust accumulation can be vacuumed 
out with another vacuum or the bag may be removed to shake 
out. If you desire, the bag may be hand laundered. The zipper 
on the bag should be down and the bag should remain right 
side out. Use warm water (150°F 65°C) and a mild detergent. 
Pre-soaking the bag in a laundry pre-soak is desirable for 
best cleaning results. Air dry thoroughly before using.
DO NOT USE AN AUTOMATIC WASHER OR DRYER as 
either will cause abrasion to the delicate polyester fabric. DO 
NOT DRY CLEAN as dry cleaning fl uids will damage plastic 
parts of your bag assembly.
Cleaner Care
CAUTION:  Turn off the switch and unplug the electrical 
cord before cleaning unit.
To keep the vacuum cleaner looking new, it can be wiped with 
a damp cloth and a mild soap solution, then thoroughly dried. 
Never use any type of chemical as chemicals can damage 
the cleaner. When not in use, the cleaner should be stored 
in a clean, dry place.
Brush Roll Belt
The brush roll belt on the upright vacuum cleaner drives the 
brush to agitate, sweep, and comb the carpet nap. The belt 
should be checked regularly to be sure it is in good condition. 
Replace the belt if it is stretching, cracking, or slipping. Cut 
away any hair or thread wound around the brush roll or the 
belt pulley because the buildup could cause the belt to rotate 
unevenly.
How To Replace A Worn Belt
PN 52100A, Style RD
CAUTION:  Turn off the switch and unplug the electrical 
cord before replacing belt. Belt pulleys can 
become hot during normal use. To prevent 
burns, avoid touching the belt pulley when 
servicing the drive belt.
IMPORTANT:  Improper  installation  of  the  brush  roll 
or brush roll belt could cause carpet or 
cleaner damage.
1.  Release cam locks.
2.  Pull up on belt to rotate it off the motor pulley. Lift up 
on brush rolL and remove worn belt.
Motor
Pulley
2
Check for brush wear (see Brush Roll instructions).
3.  Place new belt around brush roll.
4.  Align brush roll pulley with belt guide.
Metal Brush Roll only.
Place rubber end cap covers (available on select models) 
over both end caps (fl at side against end cap). Align holes 
and secure.
5.  Slant brush roll forward so end caps are in line with 
slots in cleaner base.
6.  Push brush roll into base.
7.  Place lower side of belt into belt guide and pull to 
stretch the belt around the left side of motor pulley. 
Rotate pulley to secure belt into groove.
8.  Place  slots  of  bottom 
plate over tabs of cleaner 
base.
9.   Seat  and  secure  cam 
locks.
Ask for GENUINE EUREKA
replacement belts, No. 52100A
Look for the                     symbol.
Look for the                     symbol.
GEN U INE
EUREKA PRODUCT  
Look for the                     symbol.
Look for the                     symbol.
7
6
5
8
8