Sanitaire 680 Series Manual De Usuario

1. Release cam locks and remove

bottom plate.

Check for brush wear (see Brush Roll
instructions).
3. Place new belt around brush roll.
4. Align brush roll pulley with belt guide.

7. Place lower side of belt into belt guide

and pull to stretch the belt around the
left side of motor pulley. Rotate pulley
to secure belt into groove.

The brush roll belt on the upright vacuum cleaner drives the brush to agitate, sweep,
and comb the carpet nap. The belt should be checked regularly to be sure it is in good
condition. Replace the belt if it is stretching, cracking, or slipping. Cut away any hair or
thread wound around the brush roll or the belt pulley because the buildup could cause
the belt to rotate unevenly.

2. Pull up on belt to rotate it off the  motor

pulley. Lift up on brush roll and remove
worn belt.

5. Place rubber end cap covers over

both end caps (flat side against end
cap). Align the holes and secure.
Then, slant brush roll forward so end
caps are in line with slots in cleaner
base.

6.  Push brush roll into place.

8.  Place slots of bottom plate over tabs

of cleaner base.

9.  Seat and secure cam locks.

13