HP BK715A Manual De Usuario

Step 4 - Choose Supported Options For iSCSI Infrastructure

Select each required option with quantities specified. The P4000 G2 SANs support servers with industry standard Gigabit and 10
Gigabit (SFP+) Ethernet components from various manufacturers that conform to IEEE 802.3ab (1000base-T) standards.
Description with Parts Shipped:

Description with Parts Shipped:

For details on standard Gigabit Ethernet components (including Gigabit Ethernet switches, Network Interface cards and Ethernet
cables) from HP

http://welcome.hp.com/country/us/en/prodserv/networking.html

Step 5 - Choose Rack Options

Select each required option with quantities specified.

Rack Airflow

Rack Airflow
Requirements

Requirements

Rack 10000 G2 series Cabinets

Rack 10000 G2 series Cabinets
The increasing power of new high-performance processor technology requires increased cooling
efficiency for rack-mounted servers. The 10000 G2 Series Racks provide enhanced airflow for maximum
cooling, allowing these racks to be fully loaded with servers using the latest processors.

CAUTION:

CAUTION: If a third-party rack is used, observe the following additional requirements to ensure
adequate airflow and to prevent damage to the equipment:

Front and rear doors: If your 42U server rack includes closing front and rear doors, you must allow 830
square inches (5,350 sq cm) of hole evenly distributed from top to bottom to permit adequate airflow
(equivalent to the required 64 percent open area for ventilation).
Side: The clearance between the installed rack component and the side panels of the rack must be a
minimum of 2.75 inches (7 cm).

CAUTION:

CAUTION: Always use blanking panels to fill all remaining empty front panel U-spaces in the rack. This
arrangement ensures proper airflow. Using a rack without blanking panels results in improper cooling
that can lead to thermal damage.

Rack Kit

Rack Kit
HP P4000 G2 rack models have fixed rails which provide support for racks with round mounting holes
and tool-free support for racks with square mounting holes (including Compaq/HP 7000, 9000, 10000
and HP series), with an adjustment range of 26" - 36".

Telco Rack Support

Telco Rack Support
Support for all 2 and 4 post Telco racks and threaded hole racks requires an additional option kit from
Rack Solutions. The Rack Solutions brackets can be purchased at:

www.hp.com/go/rackandpower

NOTE:

NOTE: Cat5e cables are required to connect Interface Adapters to Console Switches. Cat5e cables can
be found at the following URL:

http://www.hp.com/go/kvm

NOTE:

NOTE: It is mandatory to use a shock pallet when shipping racks with equipment installed.

NOTE:

NOTE: Please see the QuickSpecs for Technical Specifications and additional information:

http://h18000.www1.hp.com/products/quickspecs/12402_div/12402_div.html

NOTE:

NOTE: For additional information regarding Rack Cabinets, please see the following URL:

http://www.hp.com/go/rackandpower

QuickSpecs

HP P4000 G2 LeftHand SAN Solutions

Configuration Information

DA - 13552 Worldwide — Version 13 — November 14, 2011

Page 33