Windsor NWIFE 10125340 Manual De Usuario

86011370 NUWAVE 10/13/07

 

Brush PN: 12543

Brush PN:  12540

DRIVE END

FRONT BRUSH

REAR BRUSH

BRUSH
INSTALLATION 
LABEL

RETAINING
CLIPS

 
NOTE: The following service items should be per-
formed by an authorized service facility or authorized 
service personnel. All parts referred to in these 
instructions can be identified by using the parts lists 
and illustrations on the following pages. 
 

 
The dual cylindrical brush deck is designed to 
efficiently extract dirt from the carpet.  Please note the 
differences between the front/rear brushes.  Installing 
them in reverse position will significantly reduce the 
performance of the machine.  The brush part numbers 
are marked on drive ends of the brush core as follows: 
 
8.621-612.0 (12543) - Front Brush 
8.621-611.0 (12540) - Rear Brush 
 

  
 

Brushes should be replaced as a set when bristle 
length wears to height of yellow PerformAlert

 

bristles.

 
The brushes are removed from the right side of the 
machine.   
 

Adjust handle into the vertical position and lock the 
cam lever.  Tilt machine on it’s back using handle 
to support it’s position. 

 

Pull out on the bottom of the retaining clip. 

 

The brush assembly and end cap should drop 
down.  Then pull the brush down far enough to 
clear the bottom of the housing. 

 

Pull brush out with a rocking motion to free brush 
from drive hub. 

 
 
 

 

 

Make sure the brushes are in the correct position 
(front/rear) by following the brush installation label 
on the underside of the machine.  Lift the drive 
side of the brush and push it onto drive hub until a 
positive stop is felt.  The brush cannot be installed 
until the brush is fully seated on the drive hub.  

 

Pull out on the bottom of the retaining clip. 

 

Line up end cap with the flats to each side. 

 

Slide brush up into retaining clip until it clicks in 
place.